Lark for sale

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

blacklarkviii - 25 Mar 2008 02:47 GMT

Hey guys I am going to sell all my Studebaker stuff in the next little
while. I am starting with my 63 lark 2 door post. It has some rust in the
front floorboards and front fenders. It has been fixed before but really
needs to be cut out and redone. Interior is fair with bucket seats and a
console. I have replaced the 63 dash with a 64 dash. I installed a tach in
the center hole in the dash where the clock was. It aslo has a brand new set
of chevy disc brake calipers with Plymouth Trailblzer rotors. All the steel
brake lines have been replaced with new computer bent ss lines. I would like
to get $2500 for this car, but would consider offers. If no one buys it here
I will put on e-bay.
Thanks,
Henry

Reply to this Message

The Other Dave - 26 Mar 2008 21:47 GMT

Henry-

What engine/tranny? Where are you located?

> Hey guys I am going to sell all my Studebaker stuff in the next little
> while. I am starting with my 63 lark 2 door post. It has some rust in the
[quoted text clipped - 8 lines]
> Thanks,
> Henry

Reply to this Message

blacklarkviii - 26 Mar 2008 22:51 GMT

It is a 259 with a new edlebrock 500 cfm carb and a 3 speed on the column. I
have a floor shift that I bought for it but never installed. I am about 30
miles north of Charlotte, NC by way of interstate 85. I had big plans for
this car but have lost interest. There are a lot of NOS stuff in the trunk.
All new weatherstriping for the doors and trunk. A new trunk mat and other
new rubber parts. I also have another 259 engine with r1 heads that I was
planning on rebuilding with loads of performance parts from Phil Harris. It
includes cam, R3 headers, R3 intake valves, aluminum timing gear,new valve
springs and resurfaced lifters. I also have a Chevy pattern t10 4 speed with
bell housing and a 331 tt model 44 rear axle. I am going to put together a
list of all the parts I have and will sell everything I have. If someone
wants the car and all the parts I will make them a super deal.
Thanks for your interest,
Henry

Signature

Henry

> Henry-
>
[quoted text clipped - 11 lines]
>> Thanks,
>> Henry

Reply to this Message

The Other Dave - 27 Mar 2008 06:31 GMT

A bit far for my friend here in Oregon. Best luck on your sale.

> It is a 259 with a new edlebrock 500 cfm carb and a 3 speed on the column.
> I have a floor shift that I bought for it but never installed. I am about
[quoted text clipped - 27 lines]
>>> Thanks,
>>> Henry

Reply to this Message