Spongy brakes on 2004 Forester...

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

J S Narayan - 25 May 2004 01:45 GMT

Hi

I just got a new 2004 Forester and the brakes seem very spongy to me.
Funnily enough, the demo one had much firmer brakes. I did some
research and it seemed like spongy brakes were the norm back in 2001.
Do the newer models still have this "issue" or do I need to do
something about it?

I checked with the dealer and I got the usual "Oh, that is normal for
a Subaru" answer that postings on the Internet had already warned were
the expected answer from the dealer.

Thanks
JSN

Reply to this Message

name - 25 May 2004 10:41 GMT

> I checked with the dealer and I got the usual "Oh, that is normal for

Yes it is, because some Subarus come with air in the brake system.
Please ask them to bleed it out, or do it yourself.

Reply to this Message

TG - 25 May 2004 21:20 GMT

Bleed the brakes and get some non expanding stainless steel braided lines
like Goodrich or similar. TG

> Hi
>
[quoted text clipped - 10 lines]
> Thanks
> JSN

Reply to this Message

Edward Hayes - 26 May 2004 01:05 GMT

If you put a few hundred miles on the brakes by breaking them in and they
still feel spongy compared to other Forester have the dealer check them and
FLUSH the brake system with new fluid. ed Hayes

> Bleed the brakes and get some non expanding stainless steel braided lines
> like Goodrich or similar. TG
[quoted text clipped - 13 lines]
> > Thanks
> > JSN

Reply to this Message

StopSpam - 26 May 2004 22:48 GMT

This might not be your problem, but:

NEVER add brake fluid from a can you've had sitting around the garage--throw it out! ALWAYS use fresh brake fluid. It's hydroscopic, absorbs water, which gives a spongy feel to the pedal and can cause the interior steel parts of the brake system to rust! If you enjoy your car and push it on mountain roads heat form braking can cause the water in the fluid to boil which then causes "fade". A scary thing to experience. Been there, done that! You can buy one-person flushing devices pretty cheap.

> If you put a few hundred miles on the brakes by breaking them in and they
> still feel spongy compared to other Forester have the dealer check them and
[quoted text clipped - 16 lines]
> > > Thanks
> > > JSN

Username munged by FixNews

Reply to this Message

J S Narayan - 27 May 2004 06:49 GMT

> This might not be your problem, but:
>
> NEVER add brake fluid from a can you've had sitting around the garage--throw it out! ALWAYS use fresh brake fluid. It's hydroscopic,

absorbs water, which gives a spongy feel to the pedal and can cause
the interior steel parts of the brake system to rust! If you enjoy
your car and push it on mountain roads heat form braking can cause the
water in the fluid to boil which then causes "fade". A scary thing to
experience. Been there, done that! You can buy one-person flushing
devices pretty cheap.

Thanks for the tip. My Forester has about 100 miles on it so I have
not yet reached that stage.

- JSN

Reply to this Message

Edward Hayes - 27 May 2004 14:27 GMT

Let the dealer do their job to avoid any complications later. I would not
flush my brake system myself while under warranty because if a major problem
occurs then YOU (who are not a brake certified technician) will be held as
the problem. Ed

> > This might not be your problem, but:
> >
[quoted text clipped - 11 lines]
>
> - JSN

Reply to this Message