Home | Contact Us | FAQ | Search & Site Map | Link to Us
Sign In | Join | Other 45 Sites in Network
HomeAnnouncements
Discussion Groups
By Brand
BMWChevroletDodgeFordGMHondaLexusMercedes-BenzNissanPeugeotToyotaVolkswagenOther Brands
By Topic
4x4 CarsRVsDrivingMaintenance & RepairCar AudioCollectible Cars
Country Specific
Australian ForumsUK Forums
ArticlesAuto InsuranceBuyingCars & TechnologyMaintenanceMiscellaneousSafety
DMV Resources
Related Topics
MotorcyclesBoatsMore Topics ...

Car Forum / Toyota / Camry / August 2006

Tip: Looking for answers? Try searching our database.

A few more ? on my 88 Camry

Thread view: 
Enable EMail Alerts  Start New Thread
Thread rating: 
geronimo - 27 Aug 2006 19:50 GMT
THe engine runs good now, and replacing the oil pump w/crankshaft seal
fixed the oil leak.

First, there is a sensor mounted on the coolant inlet manifold which
the upper radiator hose connects to. It is mounted vertically on the
top side. The connector is broken...working for now, but needs to be
replaced. What is this sensor? (Or is it another temp switch?), so I
can get a replacement ordered?

Second,  I am a bit concerned about the temp gauge running more than
mid-scale. It will run at the very top of the little thermometer
symbol when cruising at 70 on the hwy....that is still a ways below
the red zone. I have two good fans both blowing like crazy, a new
water pump, and new thermostat which was tested in a pan on the stove,
so I know it opens fully.  The upper hose gets hot a minute or so
after starting car, so I think coolant is circulating.  I has new
coolant, no leaks. Radiator appears to be in good condition, probably
was replaced by former owner not long ago.  Radiator/condenser air
flow is not blocked.   I had to replace the (gauge) temp.
sender/sensor, the terminal broke off of it....so I thought perhaps
its temp/resistance curve was not quite the same as OEM part, so I
was not getting correct indication on the gauge.   So with the car
idling, I aimed my IR temp sensor gun at the thermostat housing and
checked temp. It was cycling between about 205 and 214 degrees, as the
fan cycled on/off. I was thinking it should  be more like 195 at idle,
am not sure.  I think the actual coolant temp is slightliy higher,
since the fans blowing on surface of the thermostat housing is bound
to cool it slightly.   Come to think of it, there is probably not
supposed to be a significant difference between temp gauge at idle and
at hwy speed if there is adequate cooling, right?
If it is really running 10 degrees hotter than normal, what can I do
or check?  When I worked in the instrumentation field we had things
called FLOWMETERS....no such luxury with auto engines!

  Anyway is this a temp that is cause for concern?

I don't want to recharge the AC until I am sure I have the cooling
system working normally, as the compressor (and heat from condensor)
will put even more heat load on the engine.

Thanks, Geronimo
sqdancerLynn - 28 Aug 2006 10:17 GMT
Don't assume that it has been replaced have the radiator checked   CHeck
the parts diagram at your dealer for the connector piece
Kurt Krueger - 28 Aug 2006 16:04 GMT
> THe engine runs good now, and replacing the oil pump w/crankshaft seal
> fixed the oil leak.
[quoted text clipped - 4 lines]
> replaced. What is this sensor? (Or is it another temp switch?), so I
> can get a replacement ordered?

Most likely it's the temp sensor used by the ECU.  Otherwise it's the
temp sensor used by the temp gauge.  Disconnect it and you'll find
out.  Either the temp gauge will stop working or the ECU will throw
a code.

Unless it's something totally different ......
geronimo - 29 Aug 2006 20:23 GMT
Yea it is the ECU temp sensor. thanks!      Youre probably right about
the radiator being clogged, will flow-check it!    Thanks, Geronimo

>> THe engine runs good now, and replacing the oil pump w/crankshaft seal
>> fixed the oil leak.
[quoted text clipped - 11 lines]
>
>Unless it's something totally different ......
 
Sign In
Join
My Latest Posts
My Monitored Threads
My Blog
My Photo Gallery
My Profile
My Homepage

Start New Thread
Enable EMail Alerts
Rate this Thread



©2008 Advenet LLC   Privacy Policy - Terms of Use
This website includes both content owned or controlled by Advenet as well as content owned or controlled by third parties.