96 Signal lights flashing after ignition turned off

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

Jurgen - 27 Jan 2006 00:00 GMT

Vehicle: 1996 4Runner, SR5 V6, 5 speed manual

Problem: Signal and dash lights flash and chime sounds after turning off
ignition and removing key.

Help

Reply to this Message

Joe - 27 Jan 2006 18:55 GMT

Hi some things to check. Ensure that the hazard switch isn't sticking on,
(operate harshly to unstick works sometimes) An alarm fault. A bad earthing
point.

Joe

> Vehicle: 1996 4Runner, SR5 V6, 5 speed manual
>
> Problem: Signal and dash lights flash and chime sounds after turning off
> ignition and removing key.
>
> Help

Reply to this Message

Jurgen - 27 Jan 2006 22:29 GMT

> Hi some things to check. Ensure that the hazard switch isn't sticking on,
> (operate harshly to unstick works sometimes) An alarm fault. A bad earthing
[quoted text clipped - 8 lines]
>>
>>Help

Thanks for replying. The hazard switch is fine - the lights only flash
after the engine is off and the key has been removed... However, the
aftermarket alarm system, that's had its power disconnected for some
time, may be the culprit - my weekend project to clean it up...

Jurgen

Reply to this Message