Air Mass Meter?

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

Matthew Pierce - 28 Oct 2004 12:39 GMT

I limped home yesterday. Chugged accross the George Washington Bridge in
second gear. What makes me think its the air mass meter is the fact that
above 2000 rpm the engine was running fine, below that it was sputtering. If
it was a fuel problem (fuel pressure regulator), I wouldn't get acceleration
at any rpm.

My mechanic buddy says its the hardest thing to diagnose and that he's seen
as many as 5 Air Mass Meters swpped out before they got it right on another
volvo. He also says buy a factory and not a rebuilt part.

Anyone have similar experience?

Matt

Reply to this Message

Mike F - 28 Oct 2004 14:09 GMT

> I limped home yesterday. Chugged accross the George Washington Bridge in
> second gear. What makes me think its the air mass meter is the fact that
[quoted text clipped - 9 lines]
>
> Matt

See how the car runs with the air mass meter disconnected. With the air
mass meter disconnected the car should start and idle OK, and run fine
at low power settings.

Signature

Mike F.
Thornhill (near Toronto), Ont.

Replace tt with t (twice!) and remove parentheses to email me directly.
(But I check the newsgroup more often than this email address.)

Reply to this Message

Robie - 28 Oct 2004 22:37 GMT

Hi Matt:

I have a 98 Volvo S-70 GLT, yesterday the engine started stalling. It
stalls and cuts off at traffic lights, in parking lots, or any time I stop
or travel slow in traffic. When it shuts down, the only way to restart it
is to hold the accelerator down on the floor and it will eventually start.
Believe me, ive tried every other way to get it to start, but it wont! I
know that holding the pedal all way down does no good on fuel injection,
but it does on this one. Does any of this sound like what your car is
doing? If you have any ideas that might help please let me know..Larry

Reply to this Message

Matthew Pierce - 29 Oct 2004 03:26 GMT

Larry,

Mine turned out to be the fuel pump, not the air mass meter!

Your problem sounds a little more dramatic. Good Luck!

> Hi Matt:
>
[quoted text clipped - 6 lines]
> but it does on this one. Does any of this sound like what your car is
> doing? If you have any ideas that might help please let me know..Larry

Reply to this Message

John Robertson - 28 Nov 2004 07:33 GMT

WE found the oxygen sensor and the prepump were the problem after much drama
and $$$$$$$$$$$$$$$$$$you know who you are my guilty friends ..

> Larry,
>
[quoted text clipped - 14 lines]
>> but it does on this one. Does any of this sound like what your car is
>> doing? If you have any ideas that might help please let me know..Larry

Reply to this Message

James Sweet - 30 Oct 2004 21:18 GMT

> I limped home yesterday. Chugged accross the George Washington Bridge in
> second gear. What makes me think its the air mass meter is the fact that
[quoted text clipped - 9 lines]
>
> Matt

Unplug the AMM when the engine is warmed up, if the AMM is the problem this
should get it running pretty well though it'll run like crap when cold.
That's how I always test it.

Reply to this Message

gjlatz - 07 Nov 2004 11:52 GMT

Hello Matt,

I have 1997 v70 awd wagon with the same problem i.e. under
2000rpm the engine is really rough. My engine light has come (an upside
down Y shape bottom right on the dashboard). Just wondering if you have
fixed the prob as i'm looking for advice. Hoping it can be sorted without
taking it to the dealer.

Thanks

Garry

Reply to this Message

Michael Pardee - 30 Oct 2004 23:41 GMT

>I limped home yesterday. Chugged accross the George Washington Bridge in
>second gear. What makes me think its the air mass meter is the fact that
[quoted text clipped - 9 lines]
>
> Matt

Be aware the connector to the AMM can be intermittent, too. (Reseating can
make it worse, but I was luckier than that.) Pressing down on the AMM
connector made my idle surge to normal, and a quick cleaning with contact
cleaner made it all better.

Mike

Reply to this Message

Robie - 31 Oct 2004 20:46 GMT

Thanks for all the replys, Mike, I will clean the AMM connector with
contact cleaner, and Hope it works..thanks Robie

Reply to this Message