'95 850 threw a bunch of codes

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

Steve Sharp - 03 May 2005 00:52 GMT

Check engine light came on, here's what I have:

A2
2-4-1 ???

A3
444 No power supply to valves in hydraulic unit
213 Left rear wheel sensor, no signal on moving off
214 Right rear wheel sensor, no signal on moving off
141 Faulty pedal sensor, shorted to ground or supply
142 Faulty brake pedal switch, open or short

There have been no ABS idiot lights coming on, check engine light came
on during normal driving.

Suggestions?

Signature

Steve Sharp
stevensharp25@comcast.net
N35 59.72
W083 59 37

Reply to this Message

Mike F - 03 May 2005 13:19 GMT

> Check engine light came on, here's what I have:
>
[quoted text clipped - 18 lines]
> N35 59.72
> W083 59 37

If you're not getting the ABS light, then just reset the codes on A3.
The rear wheel sensor codes can be left over from a dyno type emission
test, or even from continually spinning the front wheels in snow. I
wouldn't worry about any of those codes unless they come back.

The A2 2-4-1 is an EGR flow fault code - probably from clogging
somewhere in the valve or piping. Usually these can be cleaned out.
The valve is mounted on the intake manifold near the throttle body,
follow the big pipe back to the exhaust manifold. Also make sure that
the hoses and wires are all connected, note the solenoid valve connected
to the hose between the EGR valve and vacuum source.

Signature

Mike F.
Thornhill (near Toronto), Ont.

Replace tt with t (twice!) and remove parentheses to email me directly.
(But I check the newsgroup more often than this email address.)

Reply to this Message