
Signature
C S Turnbull
Cheshire
UK
csturnbull@dsl.pipex,com
Clive,
Just replaced mine 2 wekkes ago.
Remove screws of inside wheel covers, 2 scews on both sides.
Remove headlight washers if any.
Reach the plasic locks and push them from behin the front bumper. The enrire
bumper should be able to move a few inches towards you, bearly enough to
replace the head light.
Cheers,
Martijn
> Anyone know if the bumper/fender has to be removed to replace headlight
> lens on 2001 V40 Thanks in anticipation
> Clive Turnbull
> Cheshire
> UK
Arnoud Helmantel - 11 Jul 2005 19:35 GMT
> Clive,
>
[quoted text clipped - 15 lines]
> > Cheshire
> > UK
Here is part of my not-yet-finished how-to page that describes the steps
I took to get the headlights out of my MY99 V40. I haven't taken a close
up look at the phase2 bumper, but this might help:
http://www.helmantel.com/volvov40/headlights_howto.html
(there is NO page 2 yet)
greetings,
Arnoud

Signature
Please use my first and last name in the address & remove '.invalid'
Mijn voor- en achternaam gebruiken in het adres zonder '.invalid'
Clive Turnbull - 12 Jul 2005 23:27 GMT
On July 11 2005, you wrote:
> Here is part of my not-yet-finished how-to page that describes the
> steps I took to get the headlights out of my MY99 V40. I haven't taken
> a close up look at the phase2 bumper, but this might help:
> http://www.helmantel.com/volvov40/headlights_howto.html
>
[quoted text clipped - 3 lines]
>
> Arnoud
Managed this today without any problem! Thank you both once again your
input saved me a lot of time and effort Regards
Clive

Signature
C S Turnbull
Cheshire
UK
csturnbull@dsl.pipex,com
Clive Turnbull - 11 Jul 2005 23:58 GMT
On July 11 2005, you wrote:
> Clive,
>
[quoted text clipped - 9 lines]
>
> Martijn
Thanks to both of you, I have printed Arnouds instructions so I am well
prepared for a try tomorrow. The one I am doing is RHD but I am sure
that will make little difference. Will post my progress. Cheers
Clive

Signature
C S Turnbull
Cheshire
UK
csturnbull@dsl.pipex,com