Pull out the ash tray to get to the fuse panel. Now pull the small cover
off around the cigarette lighter and you'll see a screw which you can
remove, now the little cubby hole (or equalizer if you have that option)
will come out and you should have a clear shot of the fuse/relay block.
I forget offhand where on there the fuel pump relay is located but it
should show it in the owner's manual if you have that, normally it's a
white rectangle. Pull it out and look at the bottom, you should see how
the base clips into molded tabs on the outer casing. A small flathead
screwdriver can carefully pry to pop the cover off. Inside you will find
a small circuit board, look at the soldering on the bottom of this,
especially at the heavy connections of the plug pins and the actual
relay assembly. If they look dried or cracked, it's advisable to reflow
them. To do this heat the joint with a soldering iron and feed some
rosin core tin/lead solder into the joint until it all flows and you get
a nice smooth fillet. Remove the iron and the joint should cool and
harden with a relatively shiny surface.