While working on a used Jetta, I had to remove the battery connection. When
completed, the radio gave a Code: 21. I have the radio code but I do not have
the instructions on how to reactivate it-No manual and the dealer wants $50
to do it.
1997 Volkswagon Jetta 2.0L
http://forum.ecoustics.com/bbs/messages/4/106673.html
from http://townhall-talk.edmunds.com/direct/view/.f0fc260/30
======SAFE MODE INSTRUCTIONS============================
* Turn on radio -- the word "SAFE" will be displayed.
* First press the MODE button and then press the SCAN button and hold them
down simultaneously until "1000" appears in the frequency display. Release
the buttons. Do not, under any circumstance, continue holding the buttons
down or press them once again. This would cause the radio to take the number
"1000" as the code number.
* Using the first four radio station buttons, enter the code number found on
your Radio Card. Use button 1 to set the first digit of the four digit code,
button 2 to set the second digit, etc. The first digit of a four digit code
must be "1". If your code number has three digits, the first digit on
display must be set blank.
* Once the code is shown on the display, press and hold the MODE button and
SCAN button simultaneously until the word "SAFE" appears in the frequency
display. Release the buttons. A radio station frequency will automatically
be displayed. The radio will now play once again.
If, when cancelling the electronic lock-up, a wrong code number is entered
by mistake, the word "SAFE" will appear in the frequency display first
blinking, and then continuous.
You can now repeat the entire cancelling procedure but only once. The number
of attempts will be shown in display.
If the wrong code number should be entered again, your radio will be locked
up for approximately one hour. The radio will not play. Leave the radio
switched on. After an hour, you can cancel the electronic lock-up as
previously described.
This cycle, two attemps - one hour lock-up continues again.
> While working on a used Jetta, I had to remove the battery connection.
> When
[quoted text clipped - 5 lines]
>
> 1997 Volkswagon Jetta 2.0L
funkyecat - 29 Dec 2007 12:21 GMT
When the radio was first turned on I got Code; 21.
>http://forum.ecoustics.com/bbs/messages/4/106673.html
>
[quoted text clipped - 39 lines]
>>
>> 1997 Volkswagon Jetta 2.0L
dave AKA vwdoc1 - 30 Dec 2007 01:58 GMT
Try leaving the radio on for about an hour to see if the display changes.
You are not alone!
http://forum.ecoustics.com/bbs/messages/4/106673.html
The radio couldn't stay normal for more than ten minutes and then back to
SAFE. Every time I did a MODE reset a number would show on the display. A
number one bigger than the last reset. And it got to 21 and now won't reset
any more.
$hit.
I have a 97 jetta and i have the safe mode.it counted up to 21 after doing
the power up mode button trick. now i can actually get "1000" due to the
"<">" simultaneous pushing. My code is a 3 digit number i left the first "1"
blank and proceeded to push in my code. I then pressed mode and scan
together MY PROBLEM IS THAT IT SAYS CODE INSTEAD OF SAFE WHEN I DO THIS,
THEN IT GOES BACK TO THE "1000". what should i do!
> When the radio was first turned on I got Code; 21.
>
[quoted text clipped - 48 lines]
>>>
>>> 1997 Volkswagon Jetta 2.0L