Gas engine 8V right?

If the power steering pump and a/c compressor is out of the way then you are
almost there.  <g>
Did you take off the a/c compressor bracket yet?  Should be a 6mm allen head
bolt that holds it at the top.  You access this bolt through maybe a plastic
plug in the upper timing belt cover.  Then you have 2 lower bolts (13mm hex
head) for the water pump.

Using large channel-lock pliers you can hold the three bolts (6mm allen
head) that hold the water pump pulley on and use the allen wrenches to
loosen those bolts.  Please clean out the area where the allen tool goes,
and make sure that tool gets fully inserted.  ;-)

You have to take off a small nut (10mm hex head) holding the W pump to the
timing cover.  Slide bolt out and don't forget to reinstall it BEFORE you
install the a/c compressor.
You have to take off 2 upper bolts (13mm hex head), and 2 lower bolts which
should already be off, holding the W pump to the block.
That should be it after the hoses are off.

I think that is it so far but memory might have forgotten something.  <g>