Re: 2002 intrepid error code p-0441

You are accessing this site in a read-only mode. For full access to all member benefits, including message posting, please login or register. Registration is completely free, simple, and takes only a few seconds.

The message you are replying to and its parents are listed in the reverse order with the most recent posts first. This might not be the whole discussion thread. To read all the messages in this thread please click here.

Re: 2002 intrepid error code p-0441

daytripper

27 Jul 2007 21:59

>>> ahve 2002 intrepid 2.7 v6 with code showing p-0441 replaced purge control
>>> valve and the engine lightg is still on and code is still in memory. can
[quoted text clipped - 15 lines]
>do I go from here? I now realize that there probably wasnt anything wrong
>with the old valve.

Glenn will straighten you out no doubt, but I would expect the purge valve to
only be actuated with the engine running and only for a short duration. Once
the purge cycle is complete that valve should never be actuated...

brokenboltz

27 Jul 2007 20:17

>> ahve 2002 intrepid 2.7 v6 with code showing p-0441 replaced purge control
>> valve and the engine lightg is still on and code is still in memory. can
[quoted text clipped - 7 lines]
>Glenn Beasley
>Chrysler Tech

Glen, just got back from holiday and checked car again.I read something on an
earlier posting of things to check.I did check for vacuum at the throttle
body and it was positive and there is no problem with the hose going to the
purge valvefrom the body. What I did then was check for power to the valve by
unplugging the connector to the valve and there was no power present with the
car running or without the car running and thje key in the on position.Where
do I go from here? I now realize that there probably wasnt anything wrong
with the old valve.

maxpower

22 Jul 2007 11:18

> ahve 2002 intrepid 2.7 v6 with code showing p-0441 replaced purge control
> valve and the engine lightg is still on and code is still in memory. can
> anyone suggest where to go from here it would be greatly appreciated!

You could have a pinched hose from the throttle body to the purge valve.
make sure the vacuum hose is connected and has vacuum.
The NVLD (Natural vacuum leak detection) switch could be at fault . A series
of test with the proper scan tool is required to check this out

Glenn Beasley
Chrysler Tech

brokenboltz	20 Jul 2007 22:40
ahve 2002 intrepid 2.7 v6 with code showing p-0441 replaced purge control valve and the engine lightg is still on and code is still in memory. can anyone suggest where to go from here it would be greatly appreciated!

Quick links: