Re: 1989 ford crown vic pulls after new brakes installed

You are accessing this site in a read-only mode. For full access to all member benefits, including message posting, please login or register. Registration is completely free, simple, and takes only a few seconds.

The message you are replying to and its parents are listed in the reverse order with the most recent posts first. This might not be the whole discussion thread. To read all the messages in this thread please click here.

Re: 1989 ford crown vic pulls after new brakes installed

noname

13 Apr 2005 12:59

Brake hose has a restriction. Rubber inside the hose old, clogged, should
have replaced those hoses with all the other work. Rookie mistake.

> car pulls hard left. I have had it back to the shop 4 times. New pads,
> new caliphers, new rotors, new seals, repack bearings, new wheel seals,
[quoted text clipped - 3 lines]
> light, stop sign, etc., it then pulls severely. Anybody have any
> suggestions? Thank you.

gyrene

13 Apr 2005 00:03

car pulls hard left. I have had it back to the shop 4 times. New pads,
new caliphers, new rotors, new seals, repack bearings, new wheel seals,
cleaned and adjusted rear brakes. Car can be driven a few miles and it
will not pull. All of a sudden when braking, it will pull. If I slam on
brakes it doesn't seem to pull. When I brake normally, i.e., traffic
light, stop sign, etc., it then pulls severely. Anybody have any
suggestions? Thank you.

Quick links: