The message you are replying to and its parents are listed in the reverse order with the most recent posts first. This might not be the whole discussion thread. To read all the messages in this thread please click here.
Re: 1989 ford crown vic pulls after new brakes installed
| Mark | 13 Apr 2005 11:29 |
>Check the air pressure in the tires obviously if you haven't already.
That advice is as good as telling him to make sure the radio isn't on.
|
| sleepdog@optonline.net | 13 Apr 2005 01:06 |
Check the air pressure in the tires obviously if you haven't already.
How about the brakes being bled? Is it possible you have air in one of
the lines?
|
| gyrene | 13 Apr 2005 00:03 |
car pulls hard left. I have had it back to the shop 4 times. New pads,
new caliphers, new rotors, new seals, repack bearings, new wheel seals,
cleaned and adjusted rear brakes. Car can be driven a few miles and it
will not pull. All of a sudden when braking, it will pull. If I slam on
brakes it doesn't seem to pull. When I brake normally, i.e., traffic
light, stop sign, etc., it then pulls severely. Anybody have any
suggestions? Thank you.
|
Sign In
Join
My Latest Posts
My Monitored Threads
My Blog
My Photo Gallery
My Profile
My Homepage