You are accessing this site in a read-only mode. For full access to all member benefits, including message posting, please login or register. Registration is completely free, simple, and takes only a few seconds.
The message you are replying to and its parents are listed in the reverse order with the most recent posts first. This might not be the whole discussion thread. To read all the messages in this thread please click here.
Re: Incorrect Battery Charging Voltage?
| Randolph | 07 Sep 2004 21:20 |
Caroline,
The voltage regulator has two settings. Under normal operation the output voltage should be 14.5 V +/- 0.6V. At idle with a warmed up engine (and a few other requirements) the voltage is dropped to save fuel. Try measuring the voltages again, but this time step on the brake pedal when you measure the voltage at idle (stepping on the brakes will force the voltage regulator into the 14.5 V mode). When you measured in February, perhaps the engine wasn't fully warmed up?
> 1991 Civic LX 4-door sedan, 1.5 Liter, manual transmission, no air conditioning, > 156k miles, here. [quoted text clipped - 31 lines] > battery isn't going to be maintained at optimal charge and so, as winter > approaches, I need to fix this. |
| Caroline | 07 Sep 2004 02:54 |
1991 Civic LX 4-door sedan, 1.5 Liter, manual transmission, no air conditioning, 156k miles, here.
Voltage at the battery terminals when the car is -- idling = about 12.7 volts -- stopped, ignition off, also about 12.7 volts
In February, these numbers were 14.5 volts and 12. 4 volts.
Internet sources say a voltage when the car is idling of around 14 volts or so indicates a properly operating charging system. So something is wrong, IMO.
I put in a new battery (Interstate) today, replacing the old one (4-years-old; Diehard; wrong climate design as I moved from up North to the Southwest in the past year?). The voltages above didn't change.
The car is on its second alternator (OEM). This 2nd alternator is 5 years and 50k miles old.
I installed a new alternator belt in June. I originally had the belt too loose, as indicated by a squeal at cold startup. I tightened it and the squeal stopped. Unfortunately I did not at this time check the battery terminal voltage.
I did shake out quite a lot of white powder (indicating some corrosion) from the battery's positive terminal's cable connector while changing the batteries.
I'm going to do the checks at http://www.honda.co.uk/owner/ConcertoManual/62sk301/16-66.pdf this weekend.
Meanwhile, has anyone seen a condition like this? If so, what was the fix?
I think this is not critical unless I do a lot of driving with the lights on (which I do not, as I drive mostly during daylight hours). But I do feel my battery isn't going to be maintained at optimal charge and so, as winter approaches, I need to fix this.
|
Quick links: