Re: 99 Accord - Could sure use a quick tip

You are accessing this site in a read-only mode. For full access to all member benefits, including message posting, please login or register. Registration is completely free, simple, and takes only a few seconds.

The message you are replying to and its parents are listed in the reverse order with the most recent posts first. This might not be the whole discussion thread. To read all the messages in this thread please click here.

Re: 99 Accord - Could sure use a quick tip

motsco_

29 Oct 2006 21:47

> Help! I'm all set to replace the ignition coil on a 1999 Accord LX 4D, 2.3
> 4cyl.
[quoted text clipped - 6 lines]
>
> Any ideas or experieces greatly appreciated

----------------------------------------

You probably need to switch to a WAY BIGGER Phillips tip, or grind a few
thousandths off the tip of the one you have. Jap phillips has a
shallower hole in it. Same is true for the screw on the distributor rotor.

'Curly'

John Smith

29 Oct 2006 17:49

Help! I'm all set to replace the ignition coil on a 1999 Accord LX 4D, 2.3
4cyl.

Problem: The two screw/bolts holding the distributor cover in place seem
nearly rounded on the outside and very soft in the slots where a Phillips
screwdriver seems to belong. I'm scared to damage them but can't get either
one started at all. A 6mm wrench is too small, the 7mm slips over the
edges.

Any ideas or experieces greatly appreciated

Quick links: