I have an 88 Jeep 5.9L with an  automatic trani,Can I install a 1970
chrysler 318 to this transmission? Are the bell housing bolt paterns the
same?  The 5.9L distributer is in the front, the 318 is in the rear.
The Jeep 5.9L engine looks nothing like a chrysler 5.9L. please reply

I live in Colorado where it is very sunny but can get snowy at times.
So, I would like a car that is a convertible but can handle the snow.
Other than the Jeep Wrangler, what other convertibles are 4X4 or all
wheel drive?

My 00 Ranger engine (3.0 ltr 6 cyl)has been squeeling for many months.  I
first changed out the tensioner bearing, it did not fix it.  I then
changed out the fixed roller bearing, again it did not fix it.  Before I
start swapping out expensive components (alternator, water pump, AC

I NEED HELP WITH A TH400 TRANSMISSION PROBLEM
 Its In My 1985 Chevy C30 Flatbed Truck The Transmission Was Rebuild
December 2004  And Was Working Good Till The 454 Engine Went Bad On
March10th 2005 I Got The Engine Rebulid November 15TH 2005 And Put It In

I put my husband's 2003 Ford Ranger in low 4wd when driving home from work
in the snow.  I did not exceed 35mph.  Now the truck is stuck in low 4WD
and will not come out.  I've tried everything that the manual said to do.
Please advise, needless to say hubby is not happy!

I have recently had problems with the injectors in my Cherokee (171,000
miles) all stock. What is the best way to clean the orofices/holes on the
intake and fuel rail? Should I use lube to make installing easier? And why
do they cost sooooo much? (quoted $94.00 ea. at NAPA

New Escalade is more luxurious, comfy, powerful
at http://www.washtimes.com/autoweekend/20051124-011227-9083r.htm

I have a 1995 Chevy 2500 4X4 that is leaking power steering fluid from the
hose on the Steering gear. I replaced the hose and it still leaks around
the metal hose end that goes through the nut on the hose end. It seeps out
rather quickly, since the hose is new, does anyone know if ...

Clutch rebuild kit and slave cylinder installed by Pep Boys- has 1000 miles
on it and seem too tight. Slips when hot, disenguages fine. Can I fix it
myself. What is problem? Air in hydraulics?
Just bought truck last week. Only true 57,000 miles!

have rust in the pistion aira ....can i put rust buster on it and work
it clean to save it...just need it for 6 moths

In the winter time my Jeep overheats and also freezes up even though there
is adequate antifreeze. Also, whenever I stop the heater gets cold
immediately, and the air conditioner doesn't work even though there are no
leaks. The speedometer also doesn't work until I turn on the ...

It has a tilt steering wheel. The wheel moves back and forth. Need to know
how to repair this?

ok 1997 Chevy 350 Vortec ......here's what happens. Starts fine when
ran daily BUT if it sits for a few days , go to start it , she turns
over but no start.....go back and try it again in 1-2 hours fires
right up...any ideas in the group? Thanks in advance.

after we intalled new power steering pump and hoses it spins out of
controll is it possiple that we put the hoses on wrong?

For the past five or six months, whenever I've taken off from the stop
position, I have felt a reasonably significant vibration through my
steering wheel and on the floor board of my  99 Chevy Blazer (4WD - 4.3
litre). At first it didn't seem to noticeable, but gradually over time