| Thread | Last Post | Replies |
|
| steering rack 325es | 09 May 2005 00:13 GMT | 2 |
fluid is leaking from the rubber boots on my steering rack. Is there a rebuild kit available? The year is an 86. How tough is the removal and replacement I just did the oil pump and pan gasket.
|
| 528 Wiper motor | 08 May 2005 23:53 GMT | 2 |
My wipers died on me for the second time in twelve months. The wiper motor needed replacement in both cases. Is there something wrong with the wiper motor design in the 528? This doesn't seem right.
|
| 325 IC Convertible Top Cover Shock | 08 May 2005 23:22 GMT | 6 |
And thank you to Jeff Strickland for answering my question about Metric to English. I just got this 91 Convertible and the Top Cover has to be held up when putting down the top. It's unhandy and I assumed that the little
|
| Help with E36 front speakers (and rear) replacements | 08 May 2005 21:23 GMT | 1 |
I have just installed my Alpine head unit and 6 cd changer in the glove box and would now like to upgrade the speakers in my E36 touring. I have been looking but can't seem to find out how hard it is to replace the front speakers (130mm or 5 1/4in) as I can see them right down far ...
|
| water in sill? | 08 May 2005 21:15 GMT | 3 |
Just started getting a sloshing sound from near side sill on my E46 when braking. On closer inspection there are drips of water coming from the sill. Firstly, is it possible that the sill can have water ingress? If so, any advice on why the water wouldn't be draining? I assume ...
|
| 320i coupe 1994 O/S outer door replacement | 08 May 2005 20:26 GMT | 1 |
Can any one please advise on how I go about replacing the outer door handle on my 1994 320 i coupe as the part that connects to the door catch mechanism has snapped.I have removed the the catch etc but cannot see how the handle dismantles. I also looking for a replacement
|
| e 36 93 325i coil question question | 08 May 2005 13:08 GMT | 4 |
Does a coil go bad when it gets hot. Runs fine for awhile then starts to miss. After about 8 miles. What cause coils to go bad is it the heat. I checked the ohms, they all read .04 or .05. Think my wires could be at fault. Thanks RAN
|
| E30: turn signal turns on brights | 07 May 2005 21:59 GMT | 22 |
I've searched the net and haven't found a solution to this problem yet. I own an 87 325iC. Starting about two years ago, with my headlights on, whenever I used the turn signal and completed a turn and it would snap back to the normal position, my high beams would come on. I ...
|
| Help!! E46 rear suspension mounting failure! | 07 May 2005 17:53 GMT | 8 |
My 2000 323Ci E46 has developed a squeak whenever i pull away or change gear. I finally decided to get underneath to see if I could locate the problem. I located the squeak to what I think is the near side mounting for the rear anti roll bar (i'm no mechanic so i could be wrong ...
|
| Timing chain slipped | 07 May 2005 09:46 GMT | 9 |
I have a 318ci year 2002 with 45000 mile up.I have just got a repai bill for 5500.00 euro to fix the engine The problem has being caused by the timing chain which skipped number of places.OR SO I HAVE BEING TOL
|
| 88 535i suspension | 06 May 2005 22:43 GMT | 10 |
Hi, I have a tough question about my 88 535i suspension. I get a problem where I can feel the tracking slowly changing while I drive, a few hours it will be one way (maybe bad), then it will be another way (good tracking like a new car). Often it will change from the previous day
|
| Metric to English | 06 May 2005 19:12 GMT | 19 |
I'm a brand new BMW owner, this last Sunday. It's a 91 325IC. I have an owners manual coming in the mail but was wondering if someone could tell me how to get the little info center to read in English instead of Metric.
|
| 88 535i swapping driver and passenger seats | 06 May 2005 17:02 GMT | 4 |
Hi, does anyone know if it is possible to swap driver and passenger seats of an 88 535i? These are leather seats with one lever at the front for moving front and back, and one lever at the door side for moving up and down. Someone told me the metal parts are built right into the ...
|
| I need a motor for a 1984 BMW 318 I | 06 May 2005 06:20 GMT | 1 |
I have a 1984 BMW 318 I manual transmission. I need a motor for this car. Where can I get a good one? I live in U.S.A. Philadelphia, Pennsylvania, any suggestions on a motor and or garage to do the job? I have a mechanics I would use but I am not tied to him. So I am willing to
|
| Brake Pad warning Light | 06 May 2005 06:12 GMT | 2 |
Replaced Front pad and sensor today. Rears good yet. Dash warning light on. Any help out there?
|