How do I connect a car amp to a home system. The amp has a remote connector
which is to be connected to the Head units turn on lead. But the Home CD
player does not have a turn on wire.
Is it possible to have this connected?

Looking for value here fellas.Any recomendations would be appreciated.
Thanks!

I have an extended cab pickup an Eclipse deck and 4 6-1/2" Eclipse
speakers.  2 are mounted in  the door panels and 2 are mounted in the
back of the cab on 2 pieces of 6" PVC.  I don't get NEAR the amount of
sound from the back speakers compared to the ones in the doors.  Is this ...

Hi I am having a big problem lately. Everytime I turn on the volume on
my headunit my amps shut down. Actually the LED stay lit meaning the
they are still powered but they stop playing. First one goes off then a
few seconds later the other one goes. As I lower the volume they both

hi i am looking for a good deal on subwoofers with an amp.

Hi to all. We bought 2004 Nissan Quest with the "satellite-ready" stereo.
Supposedly I just put in a box (somewhere), the antenna, activate, and the I
am in business. It is this box, which supposedly is a tuner unit and my
regular stereo displays all the text messages, handles ...

Problem with audio whine (sounds like alternator) through earphones.
Device is GPS unit w/ 4 wires: Standard positive (12 volt) and negative
leads, plus two to headphones.
When installed on vehicle, alternator whine is present and loud in

Is it better to use a distribution block for the ground wires of
multiple amps, or would it be better to connect each amp's ground wire
to one single bolt on the vehicle's chassis? I would think it would be
more wiser to do the latter, but I want other's opinions. What are the

just built a box for 2 10w0 jl subs. i love there subs so i raised th
jl emblem 1/4 inch on the box and covered it in marine grade vinyl. th
whole enclosure looks perfect except the emblem. i heat it and it jus
looks like a blob when it cools. i used 3m 99 glue. should i cut smal

A couple of weks ago I asked about identifying wires to install a
radio in a 1990 Toyota Corolla.  There were numerous suggestions to go
buy a Scosche adapter kit and use that which I did.
It didn't work ...  :-(

hi there!i was wondering if anyone could help me.i have purchased a kenwood
kdc-w4527g for my micra along with two 6" x 9" speakers for the parcelshelf
at the back of my car, the only problem is only one speaker works.could
anyone help me because i dont really want to pay alot of ...

I just have two questions that I want cleared up:
1. Would a 115 amp alternator be sufficient for use with one Class D
mono amp rated at 1200 x 1 RMS @ 1-Ohm, and another amp (Class A/B)
rated at 150 x 2 RMS @ 4-ohms (Total: 1500 Watts RMS)?

I hope this is the correct forum in which to post.  Thank you for taking
the time to read this.
I need to know if is there a way to physically disable my tape deck and
leave the rest of the car stereo functioning?  I drive a 2002 Jeep Grand

how many amp outputs do u need 4 a subwoofer, and 4 speakers, im buying a
indash but i think it only has 1

I am unsure how a diode is supposed to be connected across of a relay.
I have taken a picture of how I might do it, but I am not certain if
this is the correct way of doing it. Can someone take a look?
http://fstor486.i8.com/DiodeRelay1.jpg