I'd like to know if this type of engine (in a '95 Corolla, 1.6L)
is interference type or non-interference.
I've seen on the web several sites that list the 4A-FE as interference,
while others claim it's non-interference (maybe it differs for SOHC and DOHC?)

Question - Is pennzoil any good?????

 I was checking out a pretty nice 92 Caprice at a used car lot. The body leans
over to the right side though. The fender comes down over the top of the hubcap
about 2 inches on the right rear side,  and the fender on the left rear side is
slightly above the top of the hubcap.

A u-joint on my 2000 Dodge pickup acts like it may be going bad. Just what
happens when one fails completely while driving, maybe at highway speeds? Does
the driveshaft fall off? Freeze and mess up the trans or rear end? Or just make
loud noises? Mechanics have been unable to ...

I have a 2000 Impala with about 50000 miles. I found that the botht eh
tie rod end and the lower ball joints are in need of grease. they are
looking rather depleated. The tie rod end atually looks like its
starting to dry rot and may fracture.

I was wondering what the latest opinions were on one vs the other.
I've read off and on about advantages and disadvantages of each and
it's kinda confused for me.
I've got several potential applications.

This is a question I've had for a while and wonder if anyone here has
any insights.
Why do many heater cores (and maybe radiators) have different
diameters for the inlet and outlet sides. For example say a 5/8" inlet

does anybody know where the temperature gauge wire/sender that goes to the
dash is?
they replaced the thermostat and now the gauge doesn't move at all
looked in a manual, only the coolant temp sensor is listed

I use a portable air tank to top up my tires.  I just noticed that it has a
"destroy date" of 2003, i.e., supposedly isn't safe to use any more.  (I've
had it about 7 years.)
How seriously should this be taken?  Can I de-rate the max. pressure and

Who makes Pro-Tec oil filters?

I've looked through all of the data about both brands, as well as the
various opinions about each on google groups. However, neither seems
to give me a straight answer of, Which brand would be better suited
for my car? I own a 1996 audi A4 2.8L V6 12V.

I have a '89 mitsubishi colt. the speedometer generally kicks in at
about 40km/h from a stand still and works under that speed after i
have reached it. does anyone have any idea how i can fix this problem.
Thanx, Gav

What is the general wisdom re heater cores?
If one is a problem can a repair by say a competent rad shop be just
as effective or due to the difficulty the more typical SOP to simply
toss and replace?

My 9C1's cruise control doesn't work and the antilock brake light is
on.  I followed a test in my manual on the cruise control and found
that everything is working, but I'm getting no response from the speed
sensor input to the cruise control.  I've also seen that lack of speed

Autozone advertises that they can use their scantools to check the error codes
on cars, but I've been to 3 of their stores and they can't do it. One store
inserted a jumper key, then a scantool, then decided the car uses a scantool
that AutoZone does not have. Does anyone know a ...