i have a 95 chevy suburban 1500 5.7l and am trying to locate the fuel
pressure regulator in it. is there anone who will tell me where it is
and how to get to it?
thank you.

After a heavy rain, the rear passenger door gets filled with water,
sounds like the tank sloshing gas around.  Took panel off, no evidence
of water running down from seal, but door is full of water
nonetheless.  Any ideas?

I was driving and suddenly the engine starteed making knocking sounds
the engine shakes and stalls iafter a wile if you are not moving and if you
give it a little gas and rise the RPM you hear the knoking sound.
Please anyone reply me tell me what you think it could be.

I own a 1998 Chevy Prism with 113k on it, and it's high time I get
some overdue stuff done.  I live in an apartment with absolutely
nowhere to work on my car myself, so that coupled with my general
incompetence in car repairs means I'm going to take it into a shop.

Whats the best way to remove a stuck rotor. I soaked it and banged it,it wont
move.

My cars check engine light has gone on right after i replaced the
serpentine belt on my engine.  At first, The cars rpms went really low
and seemed to be chokin up as i pressed the gas pedal, after a while
driving it, it went back to its normal state but the light stays on.

Is it true that on all late model cars all the main parts like fenders,
hood, trunk, doors are all marked with the vehicles VIN No. to defer theft?

The following just began happening:  While at a minimum speed of about 30
mph (it also happens at 70) the car shutters a bit and then stops
shuttering.  It feels like I'm accelerating on a wet surface and spinning a
wheel. It just lasts for a couple of seconds.  Is it a precursor ...

                                                          93 Lincoln
Continental 3.8L
Engine runs very rich. Check engine light is on. Cannot keep it running long
enough to bring it to operating temperature which is necessary in order to

The "check collant" light on my 1992 Buick roadmaster estate
came up for some reason. I cannot figure out why.
Can someone please advise me on how to get rid of it, i
Checked the collant level and it's good, I unplugged

When you remove a seized compressor and the oil looks very black with
aluminum bits in it is it called black death?
After the compressor was removed, I flushed the whole system with a
quart of A/C Flush and Cleaner under compressed air.  I fabricated a

http://www.powerforcetools.com/kits_pf1050.asp
found it at Harborfreight for $89
http://www.harborfreight.com/cpi/ctaf/Displayitem.taf?itemnumber=8852
Is it good enough for DIY purpose to remove lug nuts, drive axel, etc.

Been hearing some knock out of my 2000 Mazda B2500 4cyl for a while. Mostly
during highway runs in a certain RPM band (around 2100). I can gas it up a
bit and it goes away. Don't drive it much but the trips are mostly back and
forth to work at around 7 miles a trip so the engine ...

Recently, I used a humidifier to mist water into the cylinders on my fuel
injected Honda. But to no effect I will now use a fuel injector and a
fuel pump to spray water mists. I will drill a hole on the throttle body. I
know that water can rust inside the injector and seize it. I am ...

I am repairing a 2003 car with air bag deployment. I bought used air bags
from a guy who supplied a vin # and title and the donor car is not stolen
but not salvage either. The registry of motor vehicles requires the title I
guess to make sure they are not stolen BUT do they care ...