I'm new to car repairs, generally, and today i wanted to change my
tranny fluid. Trouble is, the openings for the tranny and the drive
axel look very similar and i got them mixed up... So i ended up
dumping like 3/4 gallon of tranny fluid into the front drive axel

Last time I had my tires balanced at Costco they torqued the wheel lug
nuts while the car was still approx. 6-8" elevated on the lift (ie
unloaded).  They cramed a steel wedge between the tire and the floor
to keep it from turining while they  torqued the wheel.

When I start my car up the voltmeter reads between 13.6 and 13.8
(I gather this is normal). But after I have been driving for
half an hour or more, it has gradually fallen to between 12.9 and
13.2 (It never goes lower than this). I think this is a problem

My '97 Blazer, equipped with the 4.3L, V6, has quit running. For several weeks,
the truck would start & run for a short period of time (15-30) seconds & die
with a harmony of clicking relays. It would do this multiple times before it
would stay running, but once running, it was fine ...

I've got a 2000 Ford Excursion with a broken side mirror.  It's the
kind of side mirror that can telescope out or fold against the door
window.
The plastic assembly looks fine, but the top mirror is off (and

Do you think an olds 442 motor will work in my Yugo ?
What kind of supercharger and nitrous oxide kit is best ?

I broke 2 wheel studs while removing my front driver's tire to do a
brake job on my 1998 Plymouth Voyager... Is this something that can
easily be done by a pretty competent DIY'er ?
By the looks of it, I must remove the wheel hub... press out the

 I have a '92 Buick Roadmaster with climate control heater.  The blower
fan runs even when the car is shut off and key removed.  Blower is
always on high even though the display shows it set on low.
  Where do I look to fix this problem.  I really need help with this

I am looking for a M12 X 1.50 pitch flywheel bolt, 20 - 25 mm long.  It
occurs to me that this may be a bolt used on import cars somewhere.  Does
anybody have an idea of this application?
The key is I'd like 12.9 specification on the bolt.  I have found some 10.9

Hello, all.  A while back I had the timing belt replaced on my 1991 Lumina
Z-34.  This vehicle uses the GM 3.4L DOHC engine (a love/hate object - it
also likes to devour alternators).  I am aware of a number of posts over
the years to this ng about replacement timing belts being ...

Is there a cheap way to re-attach a defogger terminal that has become
disconnected from my rear window?

I've got a 30 amp Nippondenso alternator that I bought with a bracket
to use on a Ford 3.8L V6.  Everything went together just fine but the
alternator came without any wiring instructions.
I just stopped by a starter/alterator and he was very helpful.  Beside

I'm in the midst of pulling apart my engine to examine the head/head
gasket and determine the cause of coolent in the oil.
The automobile is a 1991 model year Grand Am with 197k miles on it,
engine is the quad four with DOHC.

OK.
I think I wrote about this yesterday, but my server stuff is being wierd, so
here goes again.
I recently have been working on a 94 Towncar and have to rev the engine to

The overhaul instructions for my hydraulic clutch slave
cylinder call for using a grease that's compatible with
brake fluid to pack the side of the piston exposed to
the air, this grease sits on the surface that the seal