The car is a 1989 Mercury Cougar, 3.8L V6 engine, power steering, auto
trans.
How the heck do you get the two studs on the drivers side that hold the
power steering pump bracket out?

can ny 1 1 tell me what angle i need to turn my cylinder head bolts to

Went to tighten my PS belt today, and had no problem loosening the
pivot bolt on top of the power steering pump. The lockbolt just under
the pulley however was a different issue. I couldn't get to it. My
ratchet head was too big to fit between the bolt and the side of

I looked at one the other day. DO they go good in snow?

Okay this is a ODD one.. I have a 1992 Buick Lesabre with the 3800 v6 in
it.. well I went to check the oil tonight and when I went to put the sip
stick back I missed the hole that it go's in and I think I hit the
manifold by mistake. Well I didnt turn the car completly off the ...

My cell rings all the time with text messages from Sports Teams giving
scores, Lottery Results. Unable to find out where they are coming from.
Can anyone send me text message to advise? Ray Tel 214-727-7176

This 1995 Infinity J30 with 93000 miles failed for state inspection-
car will move in drive while parking brake applied. I tighten the
10mm nut located just above the pedal, now parking brake pedal
became more firm, I can't push the car in neutral while emergency

I have been reading about making biodiesel at home from wast oil at
fast food resteraunts. Is this easy to do? DOes the diesel made run as
good as regular diesel? Will it harm the car/tractor/etc. I burn it in?
Is it economical? I am not an environmental nut but I drive alot and

  I am living in ontario and need to do emission testing every 2
years.My car is 1994 Hyundai Elentra 1.8L, and it is running fine
except emission testing
  Until now I have already failed two times, both of them are one

I have a celica 2001 GT. Yesterday the oil light flashed a couple of
times. Shortly after a rattle noise began in the engine. I checked the
oil and it was almost empty, so i filled it. The noise however did not
go away and the engine is now stalling shortly after starting the car.

My front passenger-side wheel has been making kind of a "chirping" sound
for a week now (1994 Nissan Maxima).  It happens most at low speeds (10
mph and slower), or going around curves.  Sounds a little bit like a
game call where two parts are rubbed together.

Our governor is trying to pass a bill requiring all gas sold in
Minnesota in a few years contain 20% ethanol.  Now, that is going to
require redesign of engines anyway.  So why not use methanol instead of
ethanol?

I've got a 97 Chrysler COncorde with 90K miles.
The check engine light is on and when I check the codes
I see
code 54- No camshaft position sensor signal to distributor. Problem

When I switch on the ignition but before I start the car, I've got 14
Volts. The car starts normally. As I drive, however, some odd things
are happening. When at idle, steady cruise and during decelleration, I
get 14 volts. When I accellerate, it drops to about 8 Volts, the

I have a 2000 model year Chev Express van, 2500 series, 8,600 GVWR, and I'm
told that it would have either a 9.5" ring gear or a 10.5" ring gear.  I'm
told the 9.5" is semi-floating with c-clips to hold in the axles and the
10.5" is full floating with a nut on the outer hub to ...