| Thread | Last Post | Replies |
|
| 2001 GMC Safari - Tilt Steering Controls Headlights | 04 Jun 2005 16:02 GMT | 3 |
Recently, the tilt steering on my 2001 GMC Safari started to turn on and off the headlights depending on the angle the steering wheel is tilted. When tilted fully up or completely down, the lights are on; in between they are usually off.
|
| 2000 Impala Radio removal question | 04 Jun 2005 12:54 GMT | 2 |
The Haynes manual doesn't give instructions that work for my car. Can anyone here post a link or e-mail a scan to me? Thanks, Ken Olson
|
| Keys to New Imports | 03 Jun 2005 21:38 GMT | 6 |
Everyday I drive by the auto import yards in Baltimore, MD. I was wondering how on earth they keep track of the keys of literally thousands of identical cars. Do they leave them all unlocked with the keys in the ignition or is there some sort of master key?
|
| Driveshaft replacement advice sought: '72 Dodge. | 03 Jun 2005 18:11 GMT | 2 |
Somebody GAVE me a 24-foot Dodge Motor Home, '72. It had no driveshaft so we took one off another Dodge motor home and installed it. Was driving it home and one of the bolts holding the rear yoke sheared and the driveshaft 'went': flew right off, luckily without causing an
|
| Fuel out of my Vent Rod | 03 Jun 2005 18:09 GMT | 1 |
I'm desperately seeking advice!! I have a 1966 Mustang with an aftermarket Holley 4 brl Carb. My fuel pump went out and I had to close off the fuel line. I didn't work on it for a couple months, I've not fixed it. Problem is now fuel is
|
| V6 Malibu performs better in warm/hot weather | 03 Jun 2005 14:03 GMT | 2 |
My 2000 Malibu V6 performs much better in warm to hot temperatures then on cool/cold days. Better acceleration and power and overall smoother sounding engine. There's about 92000 km on the car now. Anyone have any idea of what might give this?
|
| Speedometer Troubles | 03 Jun 2005 11:14 GMT | 3 |
I just bought a 91 Grand Am, and I found out that my speedometer isn't working. Is this a speedometer cable, or is it electronical? The previous owner had the transmission rebuilt, so i'm guessing that the speedometer has a bad connection, or isn't connected at all to the
|
| 99 Grand Marqius big dissapointrment | 03 Jun 2005 04:36 GMT | 10 |
I have a 99 Grand Marquis and it is putting me in the poor house. 111,000 miles (1) Ball Joints and tie rods $800.00 installed (2) Spark Plug Coils? $100 a piece (quantitiy unknown as of today)
|
| Brake squeaking, aftermarket pads? | 03 Jun 2005 04:34 GMT | 8 |
'02 Isuzu Axiom (similar to the Rodeo) and the front left brakes keep squeaking. Sounds like this: Squeak <pause> squeak <pause> squeak. It sounds like a bad spot on the rotor. Each time the rotor has been turned the squeak went away for about 2 days. Its been turned twice. The pads ...
|
| vibration @ acceleration | 02 Jun 2005 21:09 GMT | 1 |
i own a 94 3000gt, as i accelerate it vibrates. what could be the cause? i bought it second hand. struts, suspension?
|
| New tire, replace two? | 02 Jun 2005 17:51 GMT | 6 |
One tire is ripped up and has to be replaced. So the question is........should I buy two. The set has 29000 miles on them. Thanks
|
| Fuel Injector cleaner For Camry 2005 | 02 Jun 2005 16:50 GMT | 7 |
I bought a 2005 camry LE automatic last december (2004). And I am getting 21mpg(max) in city, havent tested on highway. I am planning to go on long drive(500miles) and was wondering if I should add Fuel Injector Cleaner for that optimum mpg.
|
| 94 tercel igniter | 02 Jun 2005 14:28 GMT | 1 |
looking for anyone w/ experience on a toyota tercel w/ igniter problems. any conection to a bad ecu? I am getting a negative signal out of ecu to igniter, but no signal from igniter to coil
|
| Tire Pressure Thoughts | 02 Jun 2005 14:07 GMT | 8 |
Many years ago the the max inflation on most tires was 35psi. The car manufacturers specified 28 to 32 psi for proper inflation(3 to 7 psi below max). Now a lot of new tires are max inflation 44psi and the car manufacturers are still reccomending 28 to 32psi(12 to16psi below max) I
|
| HELP- 2.8 L aftermarket high strenght rocker guides... anyone make ?? need em for the 1.6 rollers | 02 Jun 2005 00:41 GMT | 3 |
last summer when i rebuilt my 2.8L (1988 olds cutlass) i had put my 1.6 roller rockers in my 2.8 for a total lift of 429/429 @ .050 ((i think)i know i had to cut custom pockets into my pistons for the suckers to fit) with my comp cam.
|