Presently have a 98 LaSabre which has been an excellent car.  However, it is
known that some models of the 3800 V6 engine
have had severe problems when the plastic manfolds decompose or begin to
leak coolant into the crankcase.

Underneath the door on 1995 Red Probe GT driver's side, I have a solid foot
long scratch. Luckily there are no dents or scratches on the door or under
it - just a very nasty thick scratch and scraping of the paint. Since the
car is 10 years old, I'm not going to take it in just ...

87 bmw 325
the clutch master and slave cylinders got replaced.
Now I am trying to bleed the system to no avail.
After 20 minutes of bleeding, there is no tension in clutch pedal.

'94 Camry half shaft replacement, (passenger side with carrier bearing)
Always like to do my own work, but considering just paying the dealer
for 1.6 hrs. on this one, because I've read numerous complaints about
getting that bearing to release from its cast iron housing around the

1990 Integra, belt is 7-8 years old, 120,000 kms since last change. I
examined both sides and entire length of the belt and can find no evidence
of wear, cracks, etc. I know the replacement interval is 100,000 kms or 5
years but this belt looks like new.

Mazda 626 V6 2.5L ATX
I just replaced the water pump and the timing belt.
After this work, the car shakes badly when idle in "D". It does not
shake in any other gear. Why is this happening, the harmonic balancer?

has anybody had this code? it's on a 2000 nissan Sentra
it says catalyst system efficiency below thresh hold(bank1)
what does this mean? thanks Randy

   I'm getting a no spark condition in my 85 Chevy Caprice. It used to
only happen when the engine was warm, but now it does it cold too, and
hasn't started up for 6 hours.  I hooked up an inductive timing light
to it, cranked the engine, and got no flashing from the light.  Also

the daughters 2002 Venture needs a compressor and drier. Its the one
with the rear a/c. Price quoted ( are you sitting down?): $$$$1500$$$$$
!!!!!! Can this this be in the ballpark?  Thanx, Mel Owen

Hi guys i have a very small amount of rust starting to creep throug
un der the windscreen rubber on my Kombi
If i took the windscreen out and stripped it back to bare metal i
there any sort of paint that maybe be better than the usual unde

Have a '97 Buick LeSabre with about 65K miles on it.
Live in Northeast, and car has been garaged, porobably, about 50% of time,
although
most always in the winter time.

Many years ago, my father told me it was a good idea to release the
accelerator once in a while whilst driving in order to "suck oil past
the rings". Apparently this action aided in lubricating the rings in
order to prolong their lifespan.

I've got a '93 F-350 and I'm just having the hardest time removing the
fuel filter. This is the filter that is in-line, mounted to the frame
roughly amidships, but on the left side.
The clips that hold the fuel lines in place come off OK. I've been told

when driving van if you turn on the a/c the van goes into aneutral mode no
over drive if you put it in 3RD gear its ok but put it in overdrive and it
goes to neutral turn off the a/c and it goes back into overdrive and its ok
any help or suggestion would be appreciated

Hi everyone!!!
I'm looking docs for heavy duty equipment and heavy duty trucks....
Please help!!!!!
Yuriy