I'm doing a tune up on my '62 Chrysler and want to check the dwell.  I have
a Craftsman analog Engine Analyzer with a dwell meter function.  It has a
positive and negative cable with clamp connectors and a set of wires hooked
up to a smal metal plate with a couple of notches in ...

A friend went over a pothole in her Smart Car and the passenger airbag
deployed.  The dealer told them that air bags are not covered in the
warranty.  I appreciate that, if you have a crash, sorting out the air bag
is your responsibility, but going over a pothole??

anyone have any idea why I would have a top end noise in my 1993 sunbird 2L

I have the vehicle named above.  This morning after driving to work, I
noticed that the engine temperature was much higher than normal, and
there was coolant on the ground.  Then I tried the heat in the car, and
only cool air would blow out from the heater.  I turned off the car

New ignition switch?
1990 Geo Metro. When I bought the car, the tip of the ignition key had
already broken off inside the switch, and remains there. No problems
until yesterday when I parked, switched the car off, took the *key* out

 My 96' Grand Am has developed some strange problems in the past few
days. A little background info on the car: It has the 2.4L, 4 Cyl, DOHC
motor in it. The car has 126K miles, and has been well maintained over
the past few years that I have owned it. All filters, plugs, most

Mitchell [ 54 CDs ], Alldata 2004, [4 DVDs], [53 CDs], BMW, MERCEDES,
AUDI, year 2005 - 2003 , total 107 CDs
buy, risk-free purchase, working, tested, fully functional, very cheap
discounted price, low cost, quality OEM software,

I have a 91 Camry LE with automatic trans.  I also have an ac.
Recently, I have noticed when I stop at a light or stop sign, the car
vibrates noticeably.  If I put the car in neutral at the stop light or
sign, the vibration goes away and runs smoothly.  What would be

On V-6s, is there any reason not to have duals on each side straight on
back, no crossover?  It'd be a 3 / 3 split, one pipe off each manifold.
Or, is that the norm, these days.  Been years since I've fiddled with duals.

I am trying to take the AFM off the carb in a 1992 Nissan Sentra but
one of the screws is stuck. It is a Philips and I don't want to wreck
the screw head and  cause more problems. Is it true that using a
larger screw driver may work?

Is there a way to check the bearings/drive shaft
on a  2000 Grand AM?  The noise is intermittent
as just sometimes it runs down the highway just
fine and feels smooth as can be, and others it

I'm stumped. My dad and I are trying to fix my 93 Buick Lesabre which
isn't starting. At first I was seeing the SECURITY light on the dash. I
took it to a shop and they told me it was the key and/or tumbler. They
showed me that by turning the key to the 'on' position and then

I have a 1987 Corolla 4 door hatchback which came with 155SR13 tires.
These are becoming very difficult to find.  The car has two good rear
tires but needs front tires.  Can I put a different size tire on the
front, such as 155-80-B13, or is this a bad idea?

Hello, I have an 93 Altima.  In the morning, the engine crank, but will
not start. After sitting under the sun for 5-6 hours then It will
start. Once starts, It runs great.  If the car is in the shade, It
won't start at all. The car has new battery, alternator, starter,

My car Mazda 626 '91 exhibits some strange behaviour in humid (rainy)
weather. When I start it cold, the engine does not idle smoothly, and
has some sort of vibrations (fairly quick ones). This is an engine with
the injectors.