Home | Contact Us | FAQ | Search & Site Map | Link to Us
Sign In | Join | Other 45 Sites in Network
HomeAnnouncements
Discussion Groups
By Brand
BMWChevroletDodgeFordGMHondaLexusMercedes-BenzNissanPeugeotToyotaVolkswagenOther Brands
By Topic
4x4 CarsRVsDrivingMaintenance & RepairCar AudioCollectible Cars
Country Specific
Australian ForumsUK Forums
ArticlesAuto InsuranceBuyingCars & TechnologyMaintenanceMiscellaneousSafety
DMV Resources
Related Topics
MotorcyclesBoatsMore Topics ...

Car Forum / Driving, Maintenance, Tuning / Maintenance and Repair / November 2005

Tip: Looking for answers? Try searching our database.

ThreadLast Post  Replies
Auto Warranty Specialists14 Nov 2005 14:42 GMT5
Extended Auto Warranties for
Any Make, Model or Mileage Vehicles
We have the exact same coverage as the dealers, but
500.00 to 1000.00 less Than them with the same or better coverage!
Speedometer doesn't work on 1994 Buick Century.14 Nov 2005 13:39 GMT5
I have a speedometer that doesn't work on a 1994 Buick Century. I took
the car off the road for the summer and just put it on the road for a
winter beater. I replaced the speed sensor and also the speedometer
assembly unit. It worked OK for about 2 weeks. Now it doesn't work
Wheel removal14 Nov 2005 00:11 GMT12
My wife has a 1999 Pontiac Grand Am which needs to have the tires rotated.
Thwe wheel lugs were torqued on pretty tight but my 200 pounds on the lug
wrench managed to loosen them but unfortunately I cannot say the same for
the aluminum wheels. They are on so tight that I cannot ...
1998 Isuzu 3.4 Crank Shaft13 Nov 2005 23:44 GMT1
I pulled the motor on my 1998 Rodeo.  I am going to remove the crank,
but
the manual says the Pistons must come out.  I am sure it is obvious to
most, but why is it that the heads and pistons must come out?  It seems
bad CV boot/bad vibration?13 Nov 2005 23:05 GMT2
I don't know if these issues are related or not, looking for
advice/experience here...  Car is an '88 Porsche 944 NA, 5-speed.
1. Fairly serious vibration at 75-80 MPH.  Pushing in clutch reduces
severity of vibration but not by much.  On/off gas does not seem to
Oil pressure sending unit13 Nov 2005 21:53 GMT20
Hi, I am trying to diagnose a fluctuating oil pressure problem:
1) Does anyone know of an easy way to connect an oil pressure tester? I have
this fancy oil pressure gauge made by K-D Tools, but you need to screw the
end with the adaptors into the crankcase, in place of the sending ...
gas mileage stats13 Nov 2005 19:32 GMT1
I've analyzed the EPA's fuel efficiency statistics for 2006 and posted
the top ten most fuel efficient cars in four categories (overall,
mid-size car, American vehicles and trucks) at
http://www.infozak.com/carmileage.html.
1988 chev 2.8L emission fail13 Nov 2005 16:41 GMT4
1988 chev celebrity 2.8L failed emission tst.
readings    HC    1.63 gpm    CO     14.77 gpm    NOx   1.18 gpm
test limit    HC    0.80 gpm    CO     15.00 gpm    NOx   2.00 gpm
this car has always passed test with readings well below the test
oil analysis - lots of silicium ?13 Nov 2005 13:55 GMT76
I have been searching for oil analysis results and interpretation, since I
had oil tested which had been in the engine for only 10 miles. The oil
filter had been changed as well. It looked troubled but I was not especially
alarmed at first.
Hard start, but only after fueling13 Nov 2005 04:58 GMT4
I have a 1998 Saturn SW2 that runs almost perfectly, but has one minor
annoying problem that I want to ask about here. The vast majority of the
time, the car starts very easily with no problems, unless I am trying to
start it immediately after just having filled the fuel tank. In ...
oxygen sensor 1996 Geo Tracker13 Nov 2005 04:00 GMT2
Is this a part that someone could change easily?
strange resistance readings13 Nov 2005 01:15 GMT2
I have a 95 blazer, 4.3, auto, 4wd. runs fine up to half throttle, then
hesitates and bogs down. I replaced to throttle position sensor and
noticed something stange--when I measure the resistance directly at the
sensor, it ranges from 1.8 at idle up 6.8 at wot, I believe that is an
Burning smell12 Nov 2005 19:11 GMT14
Recently I noticed an odor in my car, smells like
burning rubber.  Not good!  It is particularly
noticeable when I am idling at an intersection.
My first thought is the tires, but that doesn't
Car overheating, does the overflow cap ever blow off or....12 Nov 2005 18:52 GMT7
I recently took my car (Hyundai Tiburon 2001) to a dealer mech. for an
overheating problem.. He stated that the thermostat in the radiator was
bad and was replaced.  I drove the car 60 miles on highway the next day
and all was fine. The day after that I was driving locally and it ...
resistance readings12 Nov 2005 18:42 GMT1
I have a 95 blazer, 4.3, auto, 4wd. runs fine up to half throttle, then
hesitates and bogs down. I replaced to throttle position sensor and
noticed something stange--when I measure the resistance directly at the
sensor, it ranges from 1.8 at idle up 6.8 at wot, I believe that is an
Pages: 1 2 3 4 5 6 7 8 9 10 11 12 13 October, 2005
 
Sign In
Join
My Latest Posts
My Monitored Threads
My Blog
My Photo Gallery
My Profile
My Homepage

Start New Thread



©2008 Advenet LLC   Privacy Policy - Terms of Use
This website includes both content owned or controlled by Advenet as well as content owned or controlled by third parties.