FRIEND,
As are you, Brandon and www.ChezBrandon.com  are intelligent and
awesome. May you have an awesome day.
A succinct warning: Elements of the Mossad, sated with cash from the

Someone from rec.autos.driving sent me here - so this is crossposted:
I just bought a 1997 Hyundai Accent (5 speed/manual trans, 136k miles)
and it's got a few kinks (as I expected, with that many miles). I'd
like to have a better idea of what's going on before heading to the

The steering column on our 83 Diesel Rabbit started making a loud knocking
sound. I noticed that a bearing had slid out of the bottom of the steering
column tube, along with some pieces of plastic that I assume were either
part of the bearing or a bearing retainer. I could push the ...

i have a 2003 ford ranger and this is the first year i have used the 4X4 on
it is all electronic no lock outs or anything like that. well today i used
the 4 wheel because i had to go through a wet feild not too muddy just wet
well afterward i went to put it back into 2 wheel drive ...

Please help!
Just rolled over my brother's 2003 Grand Cherokee in the snow. Half
over that is. Managed to get it back on its feet, but the wheels no
longer turn, in any gear (it's an automatic of course)

I bought a set of H1 SilverStars. Installed them without touching the bulbs.
After almost 3 months the left bulb blew as soon as the headlamps were
turned on. I returned the lamps for a replacement. After about 2 months both
bulbs blew simultaneously when turned on. The car is an ...

What is the best method you have found to clean an IAC sensor on a FORD
4.6l SOHC engine, or is it best to just replace it.
Thanks,
Stan

       I have a 1986 F250 7.5l 460 engine with the Duraspark II
ignition system. Would a bad ballast resistor cause my truck to not
start at all? It turns over fast but never even tries to start. It was
working fine and then I started messing around with the wires because

Just curious, is it normal for a Delco 10SI to make an audible noise
while running?  I have tried two different units in my '55 Stude and
both are somewhat noisy.  One is the one that was in the car when I
bought it.  The other is a reman that I believe to be of dubious

My 1994 Aerostar just recently will not start all the time.  It began when
I let it get almost completely empty.  It was hard to start.  I put dry
gas in it and it started all the time for a few days then one day it was
below 1/2 tank and it would not start.  Later in the day it ...

Because I bought a Craftsman and it was a POS. The bladder pops off the
stem at below the recommended test pressure! I want a decent one now.
Thanks
Dean

I parked the '67 Toronado outside jusat before the temperature got
below freezing about a month ago.  It was above 50 degreees, so I
decided to drive it today.  It started right up, just needed some power
steering fluid.

I've been trying to figure out why a Mercury Sable 89 vehicle is
leaking power steering fluid where it has to be filled up every day to
every other day.  It has a 3.0 V engine.  The leak looks like it's
leaking right above the exhaust pipe.

I have a 1995 Jeep Grand Cherokee which the turn signal has came apart.
The part that turns the wipers on/off has came off the turn signal
lever. I still have the spring that was inside and there is still a pin
through the brass rod that the piece that fell off went over but I

Does anyone have any tips for removing oxidation from vinyl dashes?
Thanks