my water pump died this morning and i plan on replacing tomorrow.
Is their any hidden problems with replacing the water pump?
the truck is a 95 nissan pickup 4cyl 5spd
I have replaced 10 or more on american cars. This is the first jap car for

I just got a CB radio for my 1995 Ford Crown Victoria.  I need some
help figuring out exactly how I should go about hooking up the radio to
a reliable power source.  I am thinking of going through the fuse block
underneith the dash, but I'm not sure which fuse to connect it to and

My car has aftermarket wheels and they are non-located -- ie.
they do not sit over the wheel hub; they are only held on by the
four studs and wheel nuts. Also they are somewhat heavier
than the factory wheels.

I have a 2003 Galant and when ever it gets cold outside the brake pedal
gets really hard. If I press the brake for a while it releases and the
pedal acts like normal. The colder it is the longer it takes.
Has anyone had this problem before? Does anyone know what causes this?

Q:  If the Left-Rear wheel is toed IN too much, which way will the car
"pull"?
-ChrisCoaster

I own a car that has iridium tipped plugs.
They are said to last up to 60K miles.
When the time comes to change them after
six years, any danger they will be seized in

I have a jeep cheroke 96 and to day while driving the check engine
light stay on, and when stop I recycle the key on-off, on-off it give
me the code :12-24-11-56 all the other code I can see but the last code
56? I cant figure it out because it's not a legit code in the book, and

Had someone come in today and ask me a question about flat tires on
4X4s. He had been out wheeling and managed to tear off the valve stem.
OOPS.
His question was does anyone make a device that could be put into the VS

i have a problem where gas is leaking from the vapor canister onto the
ground  and i need to know what i should do to fix it

I know that this is going to sound totally silly but, I just purchased
a 67 chevelle with a small block 350.  There is no oil filler cap on
either valve cover but, an oil breather cap on one of the valve covers.
I am sure this is where I add the oil (remove the breather cap) but I

i have the doggondest problem. i was replacing rotors on a 91 t-bird when i inadvertantly opened the hydrolics.  i have not been able to get any brake pressure since. i'm quite certain that there is no air in either the brake lines or the master cylinder as i have bled both ...

I have a 1997 Chrysler Sebring with 120,000 miles.  The car is my
daughter's and I just started to drive it.  I noticed when I am on a
highway going greater than 45 mph, that when I step on the gas pedal I
hear a high pitched squeeling sound.  The sound stops when I take my

Plenty of tech info and other items being added.
Please join and help us grow.
http://www.hard-parts.org/forum/index.html

Tension device on this car is a pulley mounted just above the water pump -
not the idler pulley found toward the bottom near the firewall of some
models.  Device just went slack - is it mounted by the center bolt, which I
assume is left threaded?  Or by other bolts that hold on ...

I'm looking for a wireing diagram for a 80 bus.