I just started the mower and it runs on and off with a lot of smoke.
I did drain off the mower engine oil last winter and refilled that with
5w30 after checking up  with this newsgroup.
My guess is that I put in some gas that  has been around over 6 months.

I have a 1998 Pontiac Transport Montana Extended with a dead 3.4 ltr
motor (camshaft broke and bearings are finished). Dealers are saying
only 1998 chevy, olds or pontiac 3.4 van engines would fit.
Any of you have any experience with this engine? Will a 2003 Aztek 3400

i have a holley list#8004 im trying to ajust the mixture screws and when i
turn them cw to seat the engine idles high when i back them out it starts to
stall is this normal for this carb i was told this carb has revers mixture
screws not sure does anybody know how far they should be ...

I've got pin holes in the cylinder wall of my 7.3L diesel. My research
has turned up many ways to prevent this, but I cannot find many methods
to repair.
So far all I've found is that I could have the cylinders sleeved, but

1976 Ford F150 pickup truck is having rear right brake light problem.
The rear right brake light does not come on during braking.  it also
does not come on during hazard flasher use.
1.  Rear, right and left RUNNING lights work fine.

Is there a difference in emissions standards between cars sold in U.S. and
Europe? If so, describe.
For ex., is there a difference in the emission standards between a Ford
focus sold in U.K., and Ford focus sold in U.S.? Or Mercedes, or Volvo, or

Are these standard on some cars? And what is the purpose of them? How do
they work?

i have a 1983 VW rabbit and i went to my car this morning to start it
and bam all its doing is chugging away never rolling over! does anyone
no whats wrong, probably something simple im just retarded. PLEASE HELP
ME!

I need the fireing order for my 1989 Cadillac el dorado,4.5 litter
engine,an over zealous helper crossed them,both end's

I have a 96 Geo Prizm, but I think this occurs in most types of cars.
I can insert my key but cannot turn the key.  I had it parked
yesterday, so the steering wheel was not straight.  I can move the
steering wheel a bit, about 10 degrees each direction, but it does feel

NOTE: Corrosion build-up can result in wheels sticking to the front
brake disc flange/rear hub flange after extensive service.
Use the following procedure to prevent the sticking condition from
recurring once the wheels are removed.

is this a do-it-your-self job, or is it best left to professionals?

I have a new car and would like to put a filter in the return line on
the power steering, to promote longevity of the system components.  (The
system uses a long hydraulic ram, located under the car.)
At same time, I may want to put in a cooler for the fluid - depending

I've been trying to diagnose an intermittent drivability problem in a
'95 Buick Park Ave Ultra (supercharged 3.8L V6)
for some time. Briefly described, there will be a sudden jerk or
shudder while driving. It occurs most often

For the last three years the catalytic converter on my 98 accord has
been bad according to my dealership.  I had them check my car out after
the "engine" light came on.  They said it was my cat and it should be
replaced, although I was 9k over the 80k warrenty so I opted to not