Hi all I am hoping that someone can help me out. My parents who are
older have a 97 Ford Taurus that has been sitting in the driveway for
awhile and when I drove it I noticed the brake pedal seemed squishy and
goes down quite low towards the floor board when I apply the brakes. Now

I have a atx tranny problem with my 2002 Ford Focust ZX5. 84,000
miles.
I lost overdrive. When the car is ready to shift to OD transaxle the
tranny goes into a neutral mode - the motor just revs - until I turn

I cant find my oil leak at first i was thinking the oil was shuting
back up the tube but i nearly glued it down but it was still shuting
oil all around my dip stick and parts of the top of my engine. could
this be my dipstick tube gone bad? i checked the valve cover gasket

 I have a 1992 Olds Cutlass 3.1 .  It has idled porly since I bought
it. I have replaced and checked everything.  All of the sensors are
new. Injectors are new. Fuel pressure reg. new. No vacuum leaks. New
plugs and wires.   Throdle body butterfly set correctly.  I have a scan

Hello, specialists!
What program can use a Logitech MOMO wheel to educate a driver on PC?
Best regards,
Dima

Are there any benefits to setting the parking brake before you put an
automatic transmission in Park? I've done this for years partly to use
the parking brake cable to prevent it from freezing up due to lack of
use, and partly because if I'm parked on even a slight grade, setting

I cant find my oil leak at first i was thinking the oil was shuting
back up the tube but i nearly glued the dipstick  down but it was still
shuting oil all around my dip stick and parts of the top of my engine.
could this be my dipstick tube gone bad? i checked the valve cover

I noticed today that the gap in one of the front wheel wells (gap
between the top of the tire and body) is way wider than that of the
three other tires;  I can fit my fist inside.  The other gaps are
relatively narrow.  (98 accord sedan).

I'm thinking of replacing the catalytic converter on my 98 Accord with
a straight pipe.  Would anyone like to offer any pros or cons?
Thanks, Zeke

I had a very slow moving rear ender to a SUV.  It bent my hood back a
little, (replaced), and bend back my radiator support a bit.  (5-10
degrees)
I would like to try to fix the radiator support myself.

I will look into this with google, just in case someone has some experience
to share, I post this anyway.
I had to let a car outside this winter, and regretted seeing it covered with
snow and rain. This spring I had the windows open a bit, just to have it

I'm a newbie just needed some information about an engine analyzer and
what it does.
Could someone please tell me if one needs any special knowledge to
operate it and make alterations to the engine?

I'm used to lawnmower carburetors - gravity feed, bowl, float, etc.  Now, I'm
looking at a weedwhacker, which is a little different.  It has a diaphram that
controls the needle valve, which seems clear enough.  But, I don't see how the
diaphram is operated.  

My mother was drving her car to work yesterday can caught fire
yesterday I took to a Nissan Dealer before this happened and they put a
new engine

I looked under the hood of my car (95 Grand Prix GTP) and it was quite
dirty, so I decided to spray it down with the hose. After spraying it
down and waiting about an hour for it to dry, I decided to start it up.
Immediately there was a large 'clunk' sound (possibly a backfire?) but