Sorry, I never said what engine was in the van. Its a 3.8 .  The plugs
did look very white when i replaced them.  My thoughts are the throdle
position sensor. Maby a little weak spot right in the common cruising
position.  Thanks, TP

I'm having problem with the ac on my 1998 ford explorer cycling on/off
at weird intervals.  My first thought was that it had leaked and was
low, but after buying a gauge it was found to be in the middle range of
"full".  Sometimes it will cut on when I first get in the car and may

This van is new to me and had this missing problem sence I bought it.
Sence I bought the van I've changed the spark plugs.  The original
plugs did not look to bad.  I also changed the fuel filter and the
missing problem still exists.  The engine seems to run very well.  The

Looking for a place to connect the vacuum gauge line/hose for manfold
vacuum. Have an Auto Meter Vacuum Gauge for under the dash.
Can't seem to find anything that resembles a rubber vacuum hose for
tapping into, on this engine. 2005 Buick 3800 V6.

How much does an automobile depreciate from a mechanic's wear and tear
during a repair job?
Belt buckle scratches due to not using fender covers, soiled tires from
greasy hands, grease on the upholstery / floor mat / doors from greasy

I went and got replacement seatbelt motors that go up inside the doors, from
a salvage and got a really good deal.  Now the problem is I have no clue how
to install them & don't want to pay out the butt now to get them in.  If I
had instructions, I know i could pretty much do it ...

THE  BIG  OIL  COMPANIES  DON'T  WANT  YOU  TO  KNOW  ABOUT  THIS:
         AMAZING  "" Breakthrough  Product "" !!!!!!!!!!!!
    YOUR  GOVERNMENT  EPA  HAS  TESTED  THIS!!!!!!!!!!!
    EPA  CERTIFIED  TEST  RESULTS!!!!!!!!!!!

Recently my distributor gear stripped.  I pulled the motor a part to
replace cam, and after replacing the cam I turned the new one by hand
with a couple bolts in the end of it,  and while turning I noticed the
cam walks out about a 1/8 inch like it has a lobe at the back of it.

I have a 1987 Monte Carlo w/power windows. They take forever to go up
and down. Is it the motors that need replacing? Or do I need to change
regulators or other stuff? Or is it a ground issue, being that when I
rev the motor the windows move a little quicker? This is my first time

I have a 1999 Chevy Silverado 4x4 with 64k miles, 5.3 L engine and
automatic tranny.  The truck "stumbles" at different times.  The
problem generally occurs when I first start the engine and put in gear.
 Once I begin to give it more throttle, the problem starts to

Hey, I'm going to be attending college in Fairbanks, Alaska next year,
and I just bought a truck that should handle pretty well in snowy
conditions. For those interested, it is a used 2000 GMC Sierra Ext. Cab
K1500 4x4 with a little over 70,000 miles. It's also my first vehicle,

The oil light on my '89 Daihatsu Charade (1.0L w/ 250K miles) has been
coming on at idle for the last month or so, but only after about 20 minutes
of freeway driving. My first thought was worn main bearings. (Rod bearings
were changed 100K ago, so I don't suspect a problem there ...

Hello all, I have a problem with my ac and is looking for some
help/guidance. My ac worked fine for almost a year and suddenly my
compressor froze up. I did not know that that was the problem at the
time as I took it into the local shop because I had a burning smell

THE  BIG  OIL  COMPANIES  DON'T  WANT  YOU  TO  KNOW  ABOUT  THIS:
       """ Breakthrough  Product""" !!!!!!!!!!!!!!!!!!!!!!!
           http://www.tinyurl.com/jopjz
1.]  INCREASE  GAS  MILEAGE  UP  TO  45%  NOW!!!!!!!!!!

I have just rebuilt a 88 700r4 and I am having some problems.The
transmission feels like it is only going half way into second gear,And
from a stop it will barely move with the selector in overdrive when
you rev it up.I installed a shift kit,a .500 boost valve