When I was pressing down on the brake pedal in my '94 Chevy S10 the brake
pedal briefly lost tension and went striaght to the floor with little
braking action.  Quickly, it regained tension and braking resumed.  It has
worked fine since.

I had one brake rotor which was scarred.  The mechanic told me to
replace the rotors costing another $100 more.  I asked if the rotor
could be machined (about 3/16 inch).  He said yes.  The rotor on the
other side looked fine, but he told me that it too needed to be

hello any everyone i am looking for help on how to bleed ABS brake system on
2004 nissan frontier XE v6 4x4.
I had to change the calipers and roters and in doing so i lost fluid, i re
added fluids and bled the brakes but not much happened only later on i

How can I adjust this carb to reduce emissions? Much too high in idle and
driving emission test. Plugs are a little black. Idle mixture screws adjust
only idle not driving test correct?

Hey can anyone out there help me?  I've checked the threads, but I can't seem
to find what I need.   The problem is the drivers side window on my 2000
Honda Civic won't go all the way up.  It gets about 1 inch from the top and
it sounds like the gears are not catching......any ...

I'm replacing the rotted H-pipe on my '92 Mustang LX Convertible with a
Pypes X-pipe.  I broke one stud on each exhaust header flange, removing the
old pipe.  These are the factory exhaust headers.  How are the studs held
into the flanges?  From under the car, they don't look ...

picked up a "rebuilt" master cylinder today for my race car (76 Camaro)
because the other one was leaking around the seal.
go to bench bleed it, and the new one is leaking.  worse than the
current one.  Mutter a few choice words, dig up one from parts car, and

By a independent seller:  I hate admitting this.  I can't locate the
seller. Does anyone know, if you can trade in a car with no tranny for
a new car?  Any help is greatful, Thanks

Is this the NG to ask about getting an inspection in a different
county? You know, getting around the emissions test.
                        HJ

Got a 93 oldsmobile 88 so it should have  obd I system in it.. Though
it has a 6 wire terminal. I cant seem to get trouble codes out of it..
i dont have a scanner to plug in.. and noone around town has a book for
it.. so im tryin to search online.. any help would be apprecitated..

To illustrate the reason for my question below, I have learned that the A/C
compressor on an 82-86 Capri, 82-93 Mustang, 84-86 LTD, 85 Marquis, 85-88
Cougar and 85-88 Thunderbird are all interchangeable.
Is there a book or manual (either in print, online or on CD-ROM) that lists

I recently (within the last two weeks) bought an '85 Tercel, 5 speed
Man with just under 100K miles.  I was just beginning to like the car
and it quit on me!  It's been back-firing the whole time, but i don't
know enough to know if that's a related problem.  It starts fine but

I replaced the head gasket, spark plugs and wires. The engine turns
over, but wont start.  The timing is correct.  Compression is good.  I
am getting spark and fuel.  The spark however looked weak.  So I
checked the distributor resistance between the primary and secondary

This is probaly dumb but I am usually pretty good with cars but
recently bought a Dodge Caravan and when driving to work I started it
up no problems stop for gas about 5 mins later came back from paying
for it and it was dead all I'm getting is a clicking noise. With a