I want to give my carrera 4 a new look does anyone know of a
reasonable update body kit for porsche 996 to 997. I would also like
to find a shop that could install it i am located in Brooklyn, New
York and would like to use a shop that is close to me thank you

I have been using my HVLP gun for a few years now on smaller projects and
have had good results.
I have an Isuzu pickup truck that could look nice with a new paint job but I
don't need to be a pefectionist about it.

I have a 95 Saturn Sl1 that starts fine when it is cold but is almost
impossible to start after it has warmed up. When it is warm you have
to crank it for quite some time, then it stutters for a while like it
is getting too much fuel ( also a cloud of smoke) until it smooths

Just yesterday, the transmission on my Hyundai Accent (172,000) miles
gave out.   For the last few weeks I had been noticing problems with
the shifting such as.the car slipping out of gear while in drive, but
after the car had been driven for about 10 minutes the problem seemed

i just purchased a 1991 buick skylark 3.3 .  i have pulled all necessary
maintenance on the car such as a full tune up and cant seem to get the car
in time correctly. i have replaced the coil packs but not the ignition
module. car when idoling sounds pretty good but when put in ...

Does anyone know the average cost, or a couple benchmarks on transmission
repairs?  Maybe even typical or known problems.  My 1999 GMC Jimmy 4X4,  just
got sick.
sudden, buzz/whirring noise.  Now there is no reverse.  In forward, it revs

I am seeing all these guys on Ebay that are selling manuals on CD . Where on
the net are these guys getting these ? I see no reason to spend $5.00 on
shipping for a CD . Is there a place where I could get a manual in pdf.
format over the net for the above pickup truck ?

I've got a Celebrity boat which has been having carburetor trouble
lately.  The carburetor is a Rochester Quadrajet Carburetor, Model
4MV, Rochester No.17083515.  It is used on a 1985 Chevy Marine engine,
V6/229 cu.in./ 185 Hp.  Droplets of gas can be seen in primary bores

HOW DO I GET THE CHECK ENGINE LIGHT TO GO OFF WITH OUT PAYING TO HAVE
IT RESET?

I'd always thought that any head bolts should be replaced, but even more
important for tty bolts.
Local nissan tech says no - not necessary.
Do I believe him?

I see one of the new Japanese models has this, and I think a model of
Ford does. I am sure there are others.  Anyway, how is the ratio
programmed?  Does the engine run at only a single speed?  What is the
basic program that selects the ratio?  With the torque curve on most

The East Haven High School Yellowjacket Marching Band has just
started
our fundraising campaign and I need your help.
Please help us fundraise by treating yourself to your favorite

So here is my story,
On wednesday I left work, picked up the g/f and went to the grocery
store. i went back out and my wonderful car would not start. i thought
that it was the vattery so i pulled out my good ol booster pack,

What is the max. pressure that is advisable to run through a hose that
is clamped to a steel line with an Oetiker clamp?  Assume that the steel
line is appx. 3/8" in diameter and I'm using good, high-temp, high
pressure rubber hose.

 I'm still trying to figure out the cause of the slight hesitation off idle
in my 1999 Altima.  I'll skip the history and the details of what I've tried
so far, but suffice it to say that all the regular tuneup items have been
replaced, EGR valve and passages have been cleaned, ...