I went to a Chain auto centre with a flat tyre.They suggested changing
both front tires.I did so on the same day at same centre.@ weeks later
I started hearing squealing sound when braking.I went back to same
tire centre.They said my front break need to be replaced.

I have a 1994 Dodge Ram 1500 V8 gas with a 5.2 litre.  I have been
having troubles with the transmission.  It is wet all over the bottom
of the transmission and i can not find out where it is leaking from.
It also slips and has a bad acceleration when the transmission fluid

This is the 2.2 OHV with an electric fan.
We have changed coolant and thermostat, and electric fan operates
after idling for a period of time  Temp is fine summer or winter
driving around town, comes up to temp quick and stays there.

I replace my PCV valve once a year whether it needs it or not. The last
changeout was around 6 months ago. Today I pulled the PCV valve out of the
hole that it plugs into in the valve cover and the engine did not rev up
like usual when the PCV valve is pulled out. I put my finger ...

1987 Lincoln Town Car.  Last year my rear window de-fogger (wires in
glass) worked fine.  This year only the bottom half works.  What can I
do to fix it? I don't want to put in a new rear window just for that.
The rear window was already replaced once just to get defogger to work.

 This story might be a little involved, but basically it comes down
to me having spongy brakes.
I just had the front brake pads & rotors replaced, and since then,
I've had to apply more force than I'm used to to get the same response

I just changed my Ignition Coil #5 and the car ran great for a few
hours and now I hit the breaks and the electrical went nuts and all
gages went nuts and now when the car shuts off it wont start again and
I get nothing but clicking, When I jump the car all the lights seem to

I have a 1995 Jeep Wrangler with a 2.5 liter 4 cyl. auto.  Begining
several months ago, I had problems starting it.  The problem in the
begining almost seemed climate related.  The Jeep would not start in
the AM. As the afternoon came around the jeep would always start.  It

I made a mistake and I drove my 2007 Toyota Corolla LE with parking
brake applied for approx  3-4 miles. ( with speed of 45 max)
I didnt feel anything other than the hold back, but when i was about
to park i could  feel a smell around the car.

Yesterday I went to Autozone to read codes, and I've got ''the PCM has
determined that multiple random misfires have occured in cylinder #2, #3, #4
and Troubleshooting PO300, PO302, PO303, PO304.'' What does that mean? How
expensive is to repair them?

Just wondering how difficult it is to remove and install the passenger seat
in a Smart car... If done right, it could be very handy to be able to snap
it in and out given the limited space in one of these cars.

This engine was running flawlessly. On a fairly long
highway trip, it started to misfire. By the end of the
trip I am pretty sure that there were two or more
cylinders misfiring. Please note that I had never

So, I've been doing some research, and I want to run a line-lock test
on my car to check for a bad master cylinder. I understand what to do,
but I have a simple, yet possibly stupid question: After you clamp off
the lines, do you turn the car on before stepping on the brakes? Or do

engage in 1st .It barely moves in reverse. 2nd, 3rd, and 4th gear just
spin. We've checked the fluids and TV cable, they seem fine.Can anyone
tell me why and what we can do to fix this? Thanks in advance!::::::

I have a 1996 4cyc Somonna, the problem that I am having is that when
the truck is rolling at speeds around 40km/h while in neutral or when
the truck is in gear with the clutch pushed in, the oil pressure drops
and then the truck stalls. When driving and while stopped and idling