The power seat in my '91 Grand Marquis rocks forward and backward about
half an inch. It feels like slop in the gear linkage rather than loose
bolts, but I haven't been ambitious enough to rip out the entire seat
without some assurance it's fixable. Any ideas?

We just bought a used Ford Focus with 65K miles. The igniotion switch
started to give us problems and after researching the problem I found out
that ignition cylinder failure was very common on theses cars so I replaced
the cylinder.

Hi, I have a 72 coupe deville and cannot figure out how to get the
front seat out. I have unbolted the front supports from the floor but
the rear is still stuck and I cannot find any bolts....thanks

Anybody have any idea why my Mustang keeps blowing the fuse for the dash
lightS, I have replaced it twice in the past 2
days???????????????????????????? Please HELP!!!!!:banghead:

      I have a peougot 106 desil 1996 model and its doing my head in.
i need to bleed the desil  tried disconecting the fuel lines and
pumping no joy no desil comes throught disconected the jets and tried
still no joy and yes i have fuel in the tank Will towing the car to

I have 1.6 liter '87 BMW. I am having trouble with it's Pierburg 1B2
carburetor (cold start and idle). Replacement parts are ~200 euro. In
local Weber shop I was told that I can replace it with Weber 32 ADF
(can anyone confirm this?) for ~300 euro.

The mystery has been solved when I filled the tire that was leaking on
a regular basis for months
and it started hissing loudly and then I discover a screw in it.
Discount Tire held true to their warrenty and filled the leak for no

Hi all, I just had my water pump replaced on my 1990 Chev. Celebrity.
Now I have no heat...temp is running normal, around 230-240+/- (normal
for this car) Radiator is full, checked after a 100 mile run, still
full, no leaks whatsoever. Still no heat. You can feel a slight amount

My mechanic told me I need to replace brakes very soon on my Quest
2001. He said disks are too thin and need to be replaced too. What
else do or should I replace? What parts do I need overal for this
brake service?

I have a 91 Camry LE with 190k miles.  I have had problems with fairly
high hydrocarbon levels when taking my emissions testing in the past
and I suspect that it is leaking injectors or perhaps poorly spraying
injectors.  Anyway, with 190k miles on the car, I figure the injectors

I need to replace the blower motor resistor.  Anyone have first hand
knowledge of the location of it.  Google gave me different
locatations, or maybe the same location with different access points?
I don't know- just looking for some good advice on how to get in and

... and it's under my foot.
So the consensus is pretty much that Chinese master cylinders are
crap, but what about American rebuilds such as Cardone?  I'm leaning
towards new but I could save 40 bucks with a rebuild, so do the big

I went to a Bentley, Rolls-Royce dealer, on a Sunday just to look.  It
appears the two cars are almost identical.   Is there any significant
difference between the two?
Anyone here ever own or work on these cars?

I have a1996 hyndai elantra that will up shift fine but will not down
shift upon coming to a stop.  i have installed a new pulse generator
to the tranny with no results. no check eng. light comes on. you can
stop and restart eng. and trans. will start off normally