('99 Cavalier 2.2L, auto)
Car suddenly won't start.  It was recently shut off, so the engine is
still hot.  With the key on (engine not running, natch), the temp guage
is showing cold (all the way CCW).  This is wrong, yes?  They wouldn't

Please I need Help!
Does any one know the fire piston sequence in a 3800 engine v6 for
Bonneville '02?
I have another problem, when my car is hot, the speedometer and fuel

A search was disappointing. The radiator is on a '97 Cadillac. Small
crack. Any suggestions? Is replacing the tank the only option?
--
  (||)   Nehmo   (||)

I'm trying to bleed the brakes on my 1984 Ranger, each time my
'helper' pumps the breaks I get additional air through the line on the
right rear break, does this mean that the master cylinder is in need
of replacement?

Anyone know how these things adjust.Engine had no compression.Found it
was a broken valve spring.I replaced the valve spring reinstalled
everything and have no compression.Took the cam follower(rocker arm)
off and got 150 on the cylinder.I replaced the valve lash adjuster and

After recently  replacing a rear wheel caliper and attempting to flushing the brake fluid using the
vacuum method, which did not work worth a dam producing nothing but constant bubbles in the fluid,
I hit upon the use of clear tubing which fits tightly around the bleeding nipple ...

Hi, I have AUDI A4 1,9TDI 110hore power. Can any one tell me how much
refrigerant i have to put inside to made my air-condition work? I have
outlets in front panel and under front seats.
Thank you very much,

What is the difference (if any) between the (all of them fully
synthetic) Mobil 1 "High Mileage" (for engines over 75K miles), Mobil 1
"Extended Performance" and the regular Mobil 1 (don't remember whether
it says "with SuperSyn or not)? They claim "High Mileage" has extra

My sister has been driving my truck.
She called and said she left it at the store with a blown head
gasket.  Smoke was coming out.
Will it hurt to drive the car to a shop about 5 miles away?

I am contemplating buying a new compressor for my garage. Tools I plan
to use are air ratchets, inpact gun, small die grinders, cutoff tool
and maybe a sprayer. My question is the tool that will probably put
the most demand on the compressor is the cutoff tool. Using about

I am looking for someone to do a custom suspension for me. The desired
goal is to make a modern 2006 car ride like a full floating 1970's
America car like say a 1975 Eldorado. The most likely car to modify is
the 2006 Lincoln Towncar and the target ride being the 1985 Town Car.

My 2000 Mazda Protege is smoking blue smoke at start up
until it warms up and then it clears up.
Has abt 127k on it and I am the 1st owner and have
taken great care of this car

I am trying to install Warn 9790 manual hubs to replace the automatic hubs
on my 1993 F-150.
I have removd the old hubs but the Warn hubs will not slide in far enough
for me to install the outer snap ring.

I have a toyota Celica 1.8st which has done 157k.  It is burning an
excessive amount of oil (300 miles and the dipstick goes from full to
half level)
It is not smoking visibly but I understand that could be due to the

Friend has a 96 bonneville ssei and needs to change the fluid in the
supercharger. Does anyone know how this is done?