This morning i went out to start my car but found myself out of gas.
I put in a few gallons of gas in and tried to start it again.  The
engine would start for a second and then shut off.... any ideas of
what i should do to get it running again?

I have a 96 Subaru.  Is there anything that has to be reset if I
remove the battery?  I mean, besides the radio buttons?  And the
clock?
With newer cars, is there anything that needs to be reset?  I know

My b-in law was driving is car (1994 Geo prizm) and it died shortly
after hit it a huge pothole.  We took it to the mechanic and he said
the distributor was bad.  He replaced the distributor and it still
didn't work.  We have the car back now and I was wondering what the

I recently developed a miss in the number 4 cylinder.I have changed
the plugs,and wires.Still has the miss.I have checked the Fuel
Injector and the coil pack both are good.The check engine light stays
steady at idle but blinks when the car goes over 40mph.Any ideas what

I have a little 86 mazda truck 4cyl, 5spd. i'm planning on pimping it out but
the body is in rough shape. There are huge rust holes in the bed and a
crushed rear bumper. I'm going to get a new bumper, but I need help with the
bed. A whole new or salvaged truck bed is very spendy for ...

I Can't get my headlights to work. I have a 1968 mustang, and I'm
pretty sure all the wiring is original. I replaced the headlight
switch because that also controlled the dash lighting level, which
would flicker as I juggled the switch. The headlights still don't work

I recently got a generic OBDII scan tool and I have a question.  When
the scan tool tells me the ignition timing, is that the ignition
timing as i would read it with a timing light?  On my honda civic it
is hard to see the timing marks on the crank pulley, so it would be

My 2003 Grandcaravan will crank but will not start.  The car odo give
my problem code P1388, but OBDII scaneer shows "Pass" with no trouble
code returned.  Already swapped the ASD relay with a confirmed good
one, but the car still won't start.  The battery ground terminal was

I bought the new starter for My truck but the case is larger than
the one I just removed. I held it in place and the trans cooling lines
would rub but it looks like it would bolt up ok..I think the smaller
bodied starter is probably original equipment but do'nt know for

Du möchtest SCHNELL, einfach und vor allem LEGAL an VIEL GELD kommen?!
Unbedingt LESEN!!!
Svenja David enflamehh at freenet.de
Tue May 25 20:20:42 EST 2004

In my 99 Taurus, I've noticed lately that the battery/alternator light
comes on when the engine goes over 3500 rpms.  I've noticed no
problems other than the light coming on, but I was assuming that the
voltage was going too high so I avoided doing that.

Happy holidays!
My car is a 97 chevy lumina. The car works fine in most of the times,
but when reducing the speed and do the turning, the engine cut off
sometimes. When the problem came, all the panel lights were on and I

when the vehicle is parked idling, the temperture
starts to rise, i turn the heater fan high and that seems to bring the
temp down.it smells like
antifreeze, but can't seem to locate where it's

My 1996 Cavalier has given a dts code po0341 .When i looked it up the
book reads camshaft position sensor / performance. What does that mean
exactly? Am i looking at a timing issue or what? Has the sensor
malfunctioned? Please help this Big Dummy!

If I can hear a knock. Is it a sure thing or almost certain the crank
damaged?
I hear a slight knocking sound in my 3 cyl Geo Metro. I usually rev it
pretty high to keep up with traffic, but it's starting to make me nervous.