I am restoring a 1981 Fiat Spider.  I went to replace the exhaust
manifold gasket and one of the mounting bolts is broken off.  Any
suggestions?
Thanks

The A/C compressor clutch on my wife's 2003 Grand Caravan is toast.  Bit
it today in the 114 degree Arizona "dry heat".  She wasn't very humorous
about it.
I removed the cowl and see the rubber is completely disintegrated.  This

I need a oil system schematic for a 95 powerstroke 7.3 turbo diesel. I
replaced the oil cooler and now, I show no oil pressure on teh gauge
but the stick reads full and it's pumping oil through the pump. Help!!

I have a 2001 Chrysler T&C. Shortly after passing 100K miles, the
check engine
light came on. I picked up a OBD code reader and found P0601 memory
check sum error. I have tried to clear the code, but says it can't

i boat this boat from a guy and he changed out standard marine engine
and put a standard chevy 350 engine in it.  he reversed some water
cooling lines and got some rubber pieces in the engine...he opened it
back up and got all the gunk out and he says all that is needed to be

I am replacing the clutch on an '87 Tercel sedan with a 1.5 liter 4 cyl and
5 speed manual transmission.  The car was purchased new and this is the
first time the trans has been out of it.  Before beginning, I ordered in a
new clutch kit consisting of the friction disc, pressure ...

I operate events for single men and women and always have more ladies
than men.  why is this?  The ladies who attend my events are
attractive and intelligent.  Has anyone out there got any suggestions?
Linda www.clicksingles.co.uk

Hi, I thought I would make this a separate thread from my other one
about a decent 12 volt portable heater. Now, that the in and out hoses
are pieced together in a bypass for the heater core leaking, I was
wondering.....what if later this summer I ran some Barseal (?) or

I have a 1997 Ford E150 van and will not start.  I have taken the
battery in and they say it's fine.  THe starter was bad and I replaced
it, but still I get nothing.  The interior lights, horn... nothing
works.  There is power at the starter.  When I turn the key I get

Have a new Expedition with 900 miles on it. Truck pulls to the right
slightly. Dealer said the alignment was dead on, and it maybe radial
pull. Is this possible on new tires?

My 1993 S10 Blazer is running low speed rough idle.  I replaced the
rotor and cap, spark plugs (wires are 3 years old), cleaned the EGR
valve and put a new gasket in the EGR valve.
Can anyone give me an idea of what can be causing the problem?

I have a Sears lawn tractor which is 6 yrs old. It came with a 21HP
B&S engine. A few days ago it started to run real rough at idle. If I
add about 50% chock, it run ok, but still at times can misfire.
At a 100% speed, it seems ok and can cut grass and move around ok. I

can anyone tell me the diff between car motors and boat motors. i know
exhaust manifolds are but what about the block,heads,intake, crank,etc
thanks

I recently purchased an OBD-II auto scanner. I understand the basic
obd codes, but there is also this freeze frame data that is completely
beyond me. It is stuff about short and long term fuel trim systems.
What do those percentages mean and how can I use them effectively?

1995 nissan altama gxe (no break lights) i checked the break light
switch, fuses, bulbs. can it be the third break light bulbs out? would
this cause break lights to fail? i have running lights and signels.
please help!