My friend has a '94 Camry with 4 wheel ABS, and when the brakes are
applied at low speed you hear a thumping noise in the front end
drivers side.
Both axles are good and have the sensor ring.  Both ABS sensors have

If anybody has the correct spark plug gap for this model please let me
know.  It got to running rough today and a guy at the dealership told
me it is most likely the plugs.  Just want to be sure I gap them
right.

I just bought a 2000 impala with 45000 miles. It has the 3.4 litre
engine. Automatic tranny and all the other bells and whistles (just
not the LS version).
The oil looked good. A little high if anything. So I changed the oil.

I work at the public library in Fresno, Calif. and am trying to help a
regular customer with an auto repair question.
He's working on a 1992 Lincoln Executive with a 3.8 liter V6 engine.
He says that although the engine starts fine when cold the car won't

there are a few of these in NE PA. They specify at the gate NO JACKS.
So someone please tell me how I'm supposed to remove a THM350 from a
Chevy van? Silly question, but I need to drive to Allentown (2 hrs) to
get one over the weekend.

Last week I noticed that I had a broken bolt in my GTI transmission
that I bought, I tried extracting it till the extracor broke inside, :
( now I have another spare standard 020 tranny for now, but my
question resides; how much would I need to pay a machine shop to drill

I just recently purchased a 2005 Focus ZX4.  It has a little ove
16000 miles.  My main problem is, at times, the gear shifts from 1s
to neutral.  It is very sporadic.  It might happen 3 or 4 times i
one day, and then not at all for a few days.  The shift always occur

I posted this to alt.autos.acura, the only response I got was to repost
here - I hope someone here can help me out.

Ok, the wonderful 4L60E in my friend's Blazer popped the other week, and
we're trying to extract the thing for a rebuild.  Oddly, I thought the
rebuild was going to be the hard part, but right now, we can't figure
out how to get this silly thing out.  Our big sticking point is ...

I have a 2001 Ford Crown Vic P71 Interceptor, my interior mirror broke
and I need to get the mirror off the bracket glued to the windshield.
How is this accomplished?
Thanks

Trying to fit a reversing sensor kit to my van have managed to find
wires at rear of the van but need to find the positive wire at the
front of the vehicle needs to be I presume from the switch when
engaging reverse can anybody tell me where to access a wire for the

Car had dead battery and badly corroded battery cable.  We tried to
push start it but the failure to start was expected (battery was at
ten volts).
That was one good thing about a Kettering ignition.  With a stick

I've got a 2000 B3000 and the clutch play keeps changing. Some days I
get in and it's hard and works perfectly but sometimes I get in and
it's to the floor before I can shift gears and I have to drive around
using 2nd and 4th!

1995 Z-28, 350ci, 4L60E
Dropped the tranny pan and replaced
the filter with a Pioneer filter and gasket.
I used a thin film of Permatex Blue RTV

I was wondering if someone here would know what is wrong with the
clutch, or if any adjustments are needed. The problem I have is that
the clutch only comes up almost half way back from the floor. It
doesn't come all the way up, unless you put your foot behind the