Home | Contact Us | FAQ | Search & Site Map | Link to Us
Sign In | Join | Other 45 Sites in Network
HomeAnnouncements
Discussion Groups
By Brand
BMWChevroletDodgeFordGMHondaLexusMercedes-BenzNissanPeugeotToyotaVolkswagenOther Brands
By Topic
4x4 CarsRVsDrivingMaintenance & RepairCar AudioCollectible Cars
Country Specific
Australian ForumsUK Forums
ArticlesAuto InsuranceBuyingCars & TechnologyMaintenanceMiscellaneousSafety
DMV Resources
Related Topics
MotorcyclesBoatsMore Topics ...

Car Forum / Driving, Maintenance, Tuning / Maintenance and Repair / December 2007

Tip: Looking for answers? Try searching our database.

ThreadLast Post  Replies
condensation on spark plugs, what can i do to fix it?31 Dec 2007 20:40 GMT27
i'm working on a 98 chevy cavalier. i pool out the spark plugs and 3
of them are not sparking and they have condensation. can anybody help
me. thanks.
96 Chevy 4.3L water leaking from timing chain cover31 Dec 2007 18:52 GMT5
96 Chevy 4.3L V6 water leaking from timing chain cover at front of
engine. 180,000 miles on engine.
It is trickling from the sides of the cover. There is no water in the
oil, and the water pump leak hole is dry. Would this be an intake
1991 Geo Metro: Engine coolant drain31 Dec 2007 18:33 GMT1
Hello.  Can anyone tell me if there is a coolant drain plug on the
engine block in a 1991 Geo Metro?  If so, where is it?  I don't have
access to a lift, and I would rather not explore the underside in the
middle of winter.
engine noise help needed!30 Dec 2007 21:01 GMT17
I have a 1985 Nissan Pickup (4cyl carburated engine) and it has started
to make a very bad sounding noise and I am wondering what it might me.
The noise is like a metal on metal knock and it occurs to a small
degree whenever the gas is pressed. There is no noise when I start it
Crankshaft Position Sensor replacement30 Dec 2007 02:40 GMT29
2000 Silverado 5.3L, 4X4, 167K
I need to replace the Crankshaft Position Sensor. The manual states that
after replacement it must be connected to a scan tool for a "CKP System
Variation Learn Procedure". Is this something that needs to be done at a
failed emission high NOx30 Dec 2007 00:52 GMT18
My 89 Toyota pickup recently failed emission test for high NOx (1483
std reading 2954).
I checked out the egr system as per the service manual and didn't find
anything wrong.. I changed plugs, cap, rotor, wires, pcv, air filter
Remote starts30 Dec 2007 00:43 GMT2
I bought this one.
http://cgi.ebay.ca/Chevy-Silverado-Suburban-car-ALARM-REMOTE-ENGINE-START_W0QQit
emZ140192995223QQihZ004QQcategoryZ33721QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

Paid for it December 12th and it still has not arrived.
Maybe I should have bought this one.
Change 3 of 6 spark plugs, Venture 200230 Dec 2007 00:38 GMT5
I want to change my spark plugs in my Venture 2002, but the back 3 are too
hard to get at.   Is there any good reason that I can't at least replace 3
of the 6 plugs.  Or is it all or nothing deal?    I will be selling the van
in a year from now, so will put a cheap pair of plugs to ...
2001 Ford Ranger intake leak:30 Dec 2007 00:35 GMT5
Hi my buddy brought in his 2001 Ford Ranger with an intake leag (4.0L
SOHC) both banks lean. Any ideas what kind of time to change the
gasket set out?
Thanks!
Power Steering Fluid Contamination29 Dec 2007 17:17 GMT6
A routine check of the power steering fluid in my 1999, 66k mile-Camaro was
surprising. The reservoir was full, but the fluid was medium brown and a little
frothy with a warm engine.  There were no obvious clues.  After five cycles of
suctioning out the reservoir, refilling, running ...
1990 Lebaron 3.0, problem with charging circuit28 Dec 2007 22:42 GMT12
drained one battery already. Installed a new one, but am only reading
11.8 volts while car is running (12.2 while car is off). There's about
60 milliamps of drain between negative cable and negative battery
terminal (obviously while car is off). I think this is normal, but
auto transmission problem28 Dec 2007 08:49 GMT10
i have a toyota corona AT170, 1991 model with automatic transmission.
Around one year back, it had a problem where, when put to the reverse
gear, took around one minute to actually move back. This was repaired
by replacing some rubber rings and metal plates inside the gearbox.
timing belt?27 Dec 2007 15:52 GMT8
can a stretched timing belt with 140,000 miles on it cause a car to backfire
or pop at the tailpipe,even though the timing marks line up? also can this
cause the timing on a scan tool to jump around? is there a sure way of
telling if i have a bad computer,timing belt or ...
bigger ram air27 Dec 2007 14:31 GMT3
I was wondering, would it do a car any good if the a bigger ram air is
installed?
Going extremes, a giant cone attached to the air intake system of the
engine and then mounted on the front of the car.  With that giant
Old school mechanic needs to catch up27 Dec 2007 00:39 GMT22
Please help me with this.
My dad, a brilliant diesel mechanic, who is now in his 60s has needed
to start his own auto and truck repair shop due to financial
pressures.
Pages: 1 2 3 4 5 6 7 8 9 November, 2007
 
Sign In
Join
My Latest Posts
My Monitored Threads
My Blog
My Photo Gallery
My Profile
My Homepage

Start New Thread



©2008 Advenet LLC   Privacy Policy - Terms of Use
This website includes both content owned or controlled by Advenet as well as content owned or controlled by third parties.