I have a '68 Camaro coupe (Not an RS or an SS) with a small block 327, has
PS, no AC or PB.  My Subframe is bent and needs to be replaced.
My questions are:
What are the differences between the first generation 67-69 subframes and

my PW motors have always been kind of slow and i had changed the driver
side motor once already and it's worked fine but for the first time today
when i tried to put my window up, it just made a ticking sound but hte
window would not go up. it would come down fine, but for some ...

Recently swapped from TPI to CARB, and hooked up Mallory 3 port
Adjustable Fuel Pressure Regulator. Now, to make the stock fuel pump,
'pump'.... I have to connect the existing relay to a 12 v source
(somewhere other than the ECM).....

How hard is it to change a clutch and throwout bearing on a SBC?  The
shop wants 750 bucks.  Parts would be what?  150?
--
lab~rat  >:-)

Sad, but it seems the Camaro (1985 V6 2.8L) is dieing.  The car
"lurches" when accelerating.  I took it into a shop, and they ran a
compression test saying basically:
----"It's definitely not a firing problem, its compression...What is

Looking for all Misc. Parts for a 68 Coupe 327 (Not an SS or RS) but my
priorities are:
-Front Grill (Plain Stock) With lower trim piece
-Drivers side Front fender

Hello again looking for some more help from ya'll. my car is a 1980 z28
camaro. I have non-intermittant windsheild wipers. my wipers will work when
i first put them on but, if i turn them off they dont go all of the way back
down and i have to push them down to get them to work ...

Hope someone can help out here. I have a 96' V6 Automatic which I had all
the 02 sensors changed when the vehicle had 60K miles on it.
Yesterday, the Service Light came on (Present mileage 78K)  and it revealed
that 02 Sensor 1 Bank 1  was not having enough voltage or someting like

hi hoping someone can give me some help. when i get my car up to around
60-65 i get a bad shimmy/shake you can feel it throughout the whole car.
anyone got any ideas??
TIA

Anyone know what a 1992 Camaro B4C is worth?  I've got one with a
decent paint job about 2 years old.  About 28K miles on a rebuilt
700R4, 128K miles on a strong, non-leaking, non-smoking 5.7 TPI
engine.  From what I've found there were 589 made, they turn about 270

Can someone who has experience with the following or knowledge on it
answer the following questions.
I have a 95 camaro 3.4, and am thinking of the following mods;
K&N FIPK

Hoping for some help.  I have a 91 RS (305 TBI).  It is running very
rough.  The exhaust is black & smells like gas.
I have:
  replaced the PCV valve and O2 sensor

This might be a stupid question.
I have a 95 camaro 3.4 manual.
I am thinking about installing a K&N FIPK.
I was also thinking about installing the K&N air filters.

If anyone wants them let me know. Just pay for shipping. They are for 3rd
gen Camaro. I dont have the pieces that mount to the car though (velcro in
the back and the slots in the front). I guess they would make good
replacements for whoever has them already.

Looking for all Misc. Parts for a 68 Coupe 327 (Not an SS or RS) but my
priorities are:
-Front Grill (Plain Stock) With lower trim piece
-Drivers side Front fender