| Thread | Last Post | Replies |
|
| HELP: Signal Light Works Intermittently | 31 Mar 2005 10:11 GMT | 4 |
I have a 96 Automatic and the driver sider rear signal light act up every once in awhile. I have changed the bulb a few times and it still does it. Right now the bulb doesn't seem to be blown but the signal does not work for a while then when I go over some bumps in the road, the ...
|
| Here is some good info.... | 29 Mar 2005 03:50 GMT | 1 |
...finally someone has made a website about this scam... So all you fools that bought this so called "CHIP" for your Camaros, read it..... http://www.performanceprobe.com/extras/ebayscam.htm
|
| ammeter | 27 Mar 2005 02:48 GMT | 1 |
i have a 67 camaro with the optional instrument cluster. the damn thing wants to peg the needle and smoke the gauge and high rpms and the needle has a half swing at idle. what gives? is there a shunt resistor supposed to be attached accross the leads? maybe a fusible
|
| Any alcohol drag racing forums? | 26 Mar 2005 08:22 GMT | 3 |
Trying to learn about alcohol use in a drag race car. Any web places or forums? Al
|
| Engine removal on a fourth gen | 26 Mar 2005 05:15 GMT | 1 |
I understand that although Chevrolet says the engine has to come out the bottom, it is possible to take it out the top. Neither way sounds like much fun. My question is has anyone here ever changed the motor on a fourth gen f
|
| 89? w/2.8 fixed intake leak but now back together, no fire | 26 Mar 2005 01:05 GMT | 13 |
I got the intake leak all fixed up, got all of the valves adjusted, made darn sure that when #1 was on top that the rotor pointed to #1 wire, I rolled the motor over with the coil wire off to circulate the new oil to flush some contaminates, the coil arced from the post to
|
| ammeter | 25 Mar 2005 09:11 GMT | 1 |
i have a 67 camaro with the optional instrument cluster. the damn thing wants to peg the needle and smoke the gauge and high rpms and the needle has a half swing at idle. what gives? is there a shunt resistor supposed to be attached accross the leads? maybe a fusible
|
| 1969 Indy Pace Car SS/RS | 25 Mar 2005 02:35 GMT | 1 |
Hello can anyone tell me what a mint one is going for?? I have been offered to buy one and would like to know what there going for. It is a convertible..Thanks
|
| Temperature gauge increases with air flow change in car | 23 Mar 2005 15:57 GMT | 4 |
Greetings all, I ahve a problem that is driving me nuts (no oun intended)! Whilke driving my 94 Camaro, i have noticed lately that when i change the air direction on the climate control to either defrost or panel, the
|
| Help - 67 Rear Suspension problem. | 23 Mar 2005 05:47 GMT | 5 |
I recently picked up a 67' that has a problem with the rear suspension. When I drive over a bump the tire rubs the wheel well. At rest there is about 2 inches of clearance between the tire and the wheel well. The tires are bigger then stock(275 60/R15) and it has the original ...
|
| Rims and tires | 17 Mar 2005 15:41 GMT | 6 |
I currently have 15's on my 85 Z-28, I got a nice set of 14's I'd like to use, anyone know if this will work or if it wont work or anything I need to watch out for? Thanks in advance
|
| Boiling Gasoline!!! | 17 Mar 2005 12:59 GMT | 1 |
I own an '89 IROC Z28 with a 5.7 TPI. After about an hour of driving the car, the fuel pump will start to whine and actually cause the car to stall. If you pull the cap off of the gas tank, you can actually see white smoke coming out from inside of the tank! I have replaced the pump ...
|
| Heater hose replacement on 1st Gen w/ Air | 16 Mar 2005 13:46 GMT | 3 |
Had to replace the water pump on my '68 Camaro 327 coupe with A/C. Decided to change all the hoses too. Don't see anyway to reach the lower heater hose end at the firewall. Any suggestions?
|
| 67 camaro shell for sale | 14 Mar 2005 10:00 GMT | 2 |
I have a 67 shell for sale, no title. Make me a offer, I can send pictures if you want. NO TITLE Thank You
|
| Brake lights on a 1997 Camaro | 14 Mar 2005 04:52 GMT | 1 |
Brake lights work until the headlights come on?
|