I am trying to find out the technical info on the wheelbases of corvettes
as the years went by!  I.E. front wheel width, rear wheel width. and of
course the distance from front to back!!
I guess the best thing to get ahold of is an addy or something of that

Another OT post. But there is a diverse groups of guys here.
I have what appears to be "algae stains" on the vinyl liner of a
gunnite pool that occurred after being shut down from Hurricane Ivan.
(My mother's pool) It won't scrub off with the pool brush on a pole.

If it follows the C5 trend in depreciation, id imagine it would be in
the mid  $40 k  range in 5 years time.   Dont u think ?  

When I turn my a/c on it blows the 25 amp fuse under the dash, I hear a loud
click from what I believe is the slider for the a/c and heat. I unplugged
the wires from the compressor, cooling coil and what I think is the low
Freon switch next to the coil and it still blows the fuse ...

anybody know the time for waterpump replacement on an '84 vette?

Hand Made 2" x 3" heavy acrylic. You email me your model and year. Front
shows a picture of the corvette,how many were made that year,and base
price. Back show a picture of the engine,cid,hp. $4.99
plus $2 S/H (my actual cost) shipped from Ohio on Mondays only.

Model 1412 high perf. street Carb . See Jegs latest catalogue ;  page
78.  Also have a package of base gaskets too.  Comes with the #1480
Calibration Kit with all pieces plus some extras. Owners/Instructional
manual incl.   Carb has approx. 3,000 miles on it over 2 summers. Carb

problem did turn out to be a vacuum problem.
just as many here suspected.
the "ac two port check valve" was broken.
thanks to all who responded.

Anyone know where to tie into the 12 volts that keeps the radio going for
about 20 minutes after the car is switched off?
I would like to connect an accessory that I want on as long as the radio is
on.

GM has just released the pricing for the 2006 Corvette Z0
Z06 Base Price - $65,00
Destination - $80
1LZ Package - $0.0

Could someone please tell me the proper valve clearances for a 1965 327/375
F.I. engine ?  I've seen intake/exhaust listed as 0.24/0.30,  0.28/0.30  and
0.30/0.30.  Also, is it possible to adjust the valves cold and not have to
do it again after the engine has warmed up ?

My 1993 Vette when a/c is on the air never comes out of a steady vent,
it comes out of face vents for several minutes then it just changes by
itself, from floor to defroster. when it comes from defroster it’s  a
pain because it fogs the windshield. before I take it to the dealer I

Hi all, have an 87 convertible with the manual 4+3.  When I press the button
to activate the OverDrive, the light comes on the dash but it doesn't
engage.  The RPM's stay where there at.  Also, while slowing down in second
gear the tranny pops out of gear occassionaly??  I seriously ...

I'm considering doing a front disc brake conversion on my '63 and have been
looking at Stainless Steel Brake Corporation's  "Front Force 10 2-Piston
Aluminum Caliper Disc Brake Kit ".  I was advised by a local speed shop that
the 2 piston kit is excellent for a C2 and that a 3 or ...

Anyone remember when this was a Corvette user group where Corvette owners
helped each other with repairs and purchases?  Boy, those were the days.