Please someone help! I need a diagram or instructions to re-install my side
exhaust  on my 73. These are original 69 side exhaust not hedman. I just got
them re chromed and want to show them off but I dont remember what goes
where!

This is going to be the Vette's competitor. Comes out in 2007. Between
400-500hp with price starting around $66k. Kinda ugly, but a Nissan
nevertheless.
http://www.gtrproto.com/

The drivers side headlight door sags a little on my 1991 corvette.  I
found that the teeny rod bushings that connects the motor to the "hinge"
are worn out.  Anyone know where I can find them?  Would this be a
dealer item?  Or do they make a "complete" bushing kit for the whole

I can't lock the steering wheel or remove the key.  I know there is a
link from the shifter (4 + 3 tranny) to the steering column.  How do I
get at the shifter linkage to check the connection?  I have the service
manual but it doesn't address this.

I've found, while cleaning out my garage, a
set of heads a friend of mine gave to me a
few years back, in return for some $ owed.
Not sure if these match, but the numbers

Does anyone know how to get to the front parking light on a C-5?

Does anyone know if a T56 will fit in a '68? Would it bolt up to an old sbc?
Are there any kits available for the conversion?

Just replaced all 8 stock GM fuel injectors on our vette with some pink
top Bosch D9B-22lb injectors from fiveomotorsport.  The installation
went great and the car runs great now.  One thing we did notice is that
these seem to tick rather loudly compared to the old GM stock ones.

I want to replace all of the rear end bushings+bearings while I have the
entire assembly out of the car. I had replaced the large bearing in the
pass. side trail arm years ago after it failed and it was a major job, as I
did it while trail arm was still on the car. I believe that ...

LOLOLOLOL OMG that's funny!
http://forum.e46fanatics.com/showthread.php?t=300999
"Please let me know how I might know if he is smoking, taking or licking
them."

My vette runs great when it's first started, gas mileage is good. When I
shut it off, and restart it, it runs rough and has no power, and the gas
mileage is cut in half.
We replaced the coil, and distributor cap, and same thing.

thick wall 350 block- D port heads- timing cover- wire looms- balancer-
alternator/ps brackets- ps pump- RAM AIR I-II-III NODULAR IRON CRANK
standard uncut- hi perf clutch fan for A/C GTO- nodular iron armasteel
connecting rods- 1970-72 455 HO WINDAGE TRAY KIT- much more

The headlight doors open when I turn on the parking lights.

After 30k miles the turn signals  intermittantly stop working. The manual
shows a micro relay for the flashers but not for the turn signals.
I went to my friendly chevy dealer who suggests there is no relay thatI can
change "maybe it's in the switch!" not very helpful!!

I have been a Corvette Technician for over  23  years and have started my
own shop rebuilding the Tremec and borg warner 6 speeds . I have done
hundreds of these units already. I have al the GM tools etc.
Prices are very resonable ,  complete re-seal and inspection starting at