If anyone has a line on a good buy for a decent hardtop that would fit my '64
could you let me know. Seen a few for sale but nothing close of much value.
Thanks

http://www.friendlyplanet.com/images/blue-footed-boobie-galapagos-big.jpg
http://www.dungevalley.co.uk/Birds/goldcrest.jpg
http://www.cowboyshowcase.com/images/glossary/glossa8.jpg
Enjoy

Just last week my '97 C5 started acting strangely. It "yaws" while
driving. Just driving along straight and flat, it suddenly jerks to
the left or right a bit. It does this when you accelerate a bit, or
let off the accelerator. Hitting even the tiniest bump causes it to do

I just purchased a 1990 Corvette. The automatic climate control lights
up but none of the functions work. No heat, no A/C, no blower motor.
Any ideas where to start?

Has anybody ever used a Hypertech Programmer Model # 345752 on a 1995 LT1?
Does it give the results that are hyped, or is it all hype?
                     Thanks,
                     Paul

FWIW, I think I read the Corvette was the 2nd most loyal following by
which the owners were most likely to buy it again.  I think the Prius
was the 1st.   Of course I don't necessarily hold consumer reports as
the ulimate source but what the heck.

Factory shop manual (1989) discusses aluminum head
considerations (anti-seize etc.) and says 22 Ft-lbs.
Happened to look in Haynes for C4s.  It says 22 Ft-lbs for
cast iron heads and 12 Ft-lbs. for aluminum heads.  Does not

I have a 1998 Corvette C5 that has been in a frontend smash. I am
looking for anyone who might have some parts or spares for sale... I
need both front fenders(wings), Hood (bonnet),front bumper and
supports, Generator(Alternator), both radiators, ABS bracket

Is there a way to replace the rear to front metal brake line in one piece
w/out removing body? I bought a new line from Zip but can't seem to find a
way to install it intact. It appears that perhaps it could be cut and
re-coupled to make it install. My concern is it has been ...

I have a '73 Vette with tilt/telescopic wheel. There is some up & down, side
to side play in the column where it tilts. Anybody familiar with this? Easy
fix or nightmare?  Thanks!

Nice Restored Vette...
Seen on another group...
news:ttWFh.535$X6.275@bignews1.bellsouth.net
news:B1WFh.524$X6.212@bignews1.bellsouth.net

PJ, you mentioned in another post you have made some mods to your
L-S1, please give me some tips/advise on things to enhance my L-S1.
Things I have done so far are...B+B  Tri-Flo headers, B+B PRT
system(cats back), Bassani X-Pipe; Twin Flow air intake, and Power Duct

I need to replace both cables on my 63 SB/ no AC. What is the correct gauge
of wire to construct the cables? Thanx- lib

I don't have any experience with Carmax and wonder if it is a good or
bad idea to consider buying a used Corvette from them?  Some of the
cars appear to be former lease cars and wonder if I should exclude
them from consideration?  If it matters I'd probably consider under 10