Any thoughts about the GPS/Nav option in a 2008? I have one on order.
Meantime I've been trying to download/read the manual to become familiar
with the options available before the car arrives (truth be told I'm
chomping at the bit and I figured that perhaps this might help me ...

Need some new parts for the '75 that include a radiator, support
corner-cushions, throttle cable, and maybe even the foam seals that direct
the air into the fan shroud.  Eckler's seems to be the least expensive
except for the radiator which is cheaper from one of the local parts  ...

Hello All Again,
After doing tremendous research I think the conversion is not very difficult
as long as certain things are compromised.  Please allow me to run these
things by everyone for comment.

My 86 roadster has developed a clicking noise behind the center
stack.  It has to have something to do with the power door locks
relay or alarm system, since it only starts when a door is opened and
only continues for exactly 3 minutes before stopping.  Anyone got any

My AC/Heat works great but it will not switch from blowing from the
floor vents to blowing out the dash vents, it use to do it aftewr a
few minutes or so but now it has stopped doing it and stay on the
floor vents no matter what switch location i put it on,should I assume

Can anyone recommend a good, reliable garage/dealer for Corvette service, in
the Atlanta area?
Thanks      FastFreddie

I'm just ready to replace my first headlight on my C4.
According to the manual I have to remove these apecial screws.
Is that suppoded to come with my tools ?
I have the ratchet wrench for the top and the sockets for removing the

to the 600hp Vette lovers salivating that it gets 100hp/liter...
big deal.
the new 911GT2 gets 147hp/liter...from a twin-turbo 3.6 liter, 6-cylinder
engine.

All,
My 2000 all of a sudden started with warnings on the dash.  The obvious "Service Engine Soon" but also "Reduce Engine..." then "Check Tire Pressure" and "Low Fuel."  The thing is that tire pressure is about 30 (which is lower than what I would like), the tank is more than ...

Guys, as some have said, let us *IGNOR*  Andrew no matter what he
says.  It is obvious he likes the attention and will say whatever to
draw more !!!   If you don't kill file him at least just IGNOR him.  
I'm trying to do this no matter how or if he replies here.   I expect

I am geeked over my C3 Vette

I'm in the middle of restoring an '82 Corvette.
We're about half way through the dash.  I've
not been able to find out what the center
defroster vents are supposed to be covered with

I need just a little advice about changing from crossfire fuel injection to
a carburated engine on a 1984 C4.
The intake and carburator shall be Edelbrock.  My question is I have been
told that I can continue to use the HEI distributator, is this possible?  If

http://www.disappearing-car-door.com/
no affiliation,
just wanted to share the idea..