I'm helping a buddy from zr2.com install his OHC next Tues.  He is
also having overheating issues and it seems that his fan clutch isn't
engaging, so we figure we'll replace the clutch.  He's had the coolant
flushed (by a GM dealer), he had the t-stat replaced before having

The AC fan won't work on high.  The fan works on the other speeds.  Also
when the control knob is on vent it partially blows through the vents and
on the floor.  Is the fan or fan switch bad and can the control knob also
be bad?

FREE GAS MILEAGE CALCULATOR
Easily check your vehicle mileage and fuel costs over multiple fill ups with
this spreadsheet in MS Excel format.  Downloads in no time. Simply email
me - jonmosero@msn.com - with 'Free Gas Calculator' in the subject line. No

My new '99 blazer has a trailer brake that I would like to remove since it
hits my shin in one position and the top of my foot at another position. Is
it ok just to cut the wires, tape them off, and then hide them? Thanks

The previous owner of a 1995 Chevy 2500 Ext Cab 4x4 had replaced the
automatic transmission.  When it is shifted into 4 wheel drive it makes a
clunking noise as if it's not fully engaged.  It has the shift lever on
the floor.  Is the linkage out of adjustment or is the transfer case

Does anyone have a link to where I can order the Factory Service manual for
my truck.  I remember Helmich Manual but I cant find it
TIA

I'm not so much of an truck enthusiast as a major do-it-yourselfer.
When I researched what manual would be best to get for my 2003
Silverado 4x4, I read most of the posts about Chilton or Haynes
manuals.  I decided to go full-blown

Grettings,
I have a 1997 Blazer 4.3.  I have been considering installing a K&N FIPK
(Fuel Injection Perfromance Kit).  Anyone have any advice on it? Also, any
advice on installing a performance module.  This Blazer has been fantastic

Dearest Group,
   I am considering purchasing a DANA 60 rear axle from a private party. I
have not seen the axle yet, it is in the next state over. Here is what I was
able to find out about the axle;

My father has a 1994 z71 with about 70k on it.  It seems to have a
serious rust problem. So far the bumper has rusted through, brake
lines have rusted through, fuel lines leaked due to rust, the
differential cover became so thin with rust, the fluid started to seep

Hey everyone,  I have a 78 chevy 1/2 ton 4x4 with the 350/350.. anyway, for
over a year now it has been 'galloping' really bad at 30-33 mph.  If I brake
through that speed, it does it, if I accelerate and/or coast through that
speed, it does it.  It feels exactly like a tire being ...

I have a 74 Chevy Pickup which I drive in the winter on rare occasions
( Why? Because my KIA 4 banger won't haul a car trailer ).  Since it's
summer, now is the time to undercoat ( no salt on the roads and fairly
dry ).

Interested in subframe connectors for 2000 Chevy S-10 4-cyl. pickup truck...
ext. cab. Any recommendations? TIA.
-Mike
--

The engine light came on in my '03 Silverado yesterday. (the second time
within a month) I took it in to the shop today and it turned out to be the
cataletic (sp?) convertor. Has anyone else come across faulty convertors?
V.B.

I just bought a 1985 k5 blazer and want to put a 12" lift on it.  What is
the best way?  I have read that people bought superlift on them, but cant
seem to find there 12" lifts.  I know (dont know why though) that you cant
block the front, only the rear.  I plan on putting 44 ...