| Thread | Last Post | Replies |
|
| Looking for a cab 1973 80? | 20 Aug 2004 08:28 GMT | 1 |
I just got a 73 3/4 4x4 and I did not notice how bad the cab is and I am looking for one. I am hoping that some one out there knows some one or knows where a good cab is. Any leads or info would be great. Thanks
|
| Vacuum Monster Strikes - long | 20 Aug 2004 03:17 GMT | 4 |
'87 Chevy pickup Low mileage (95K km, 60K miles) 4.3 ltr. V6, TBI, TH 400 Transmission. Story...
|
| timing change r&R 350 | 20 Aug 2004 03:13 GMT | 4 |
I have to change a timing chain on an 83 3/4 ton with the 350 engine. With no shop, and it being in the heat of about 100 degree's, does anyone want to hazard a guess about how long it might take, assuming no problems.
|
| S-10 exhaust kit | 20 Aug 2004 00:34 GMT | 2 |
Hey everyone, 1988 Chevy Blazer S-10 4x4 4.3L Automatic TBI I'm looking for a better-than-stock exhaust kit. My catalytic converter (I'm fairly sure) is shot/clogged and I have an exhaust leak in the donuts
|
| Avalanche Boating | 19 Aug 2004 22:55 GMT | 5 |
A few weeks ago I went on a road trip with the wife and kids. We took her Avalanche. On the way back we discovered that we had all had way too much fun, but I was the only one awake enough to drive home. I noticed that it tended to boat. Sometimes what I thought was pretty bad.
|
| 98 GMC Suburban Wiper Problems | 19 Aug 2004 22:50 GMT | 2 |
I have read many posts on the wiper problems associated with several models. Is or was this a recall? I have a 98 GMC Suburban that I just bought. Do I just call GMC to get the info? I have NHTSA Campiagn number: 98V150001
|
| 4.3l stumble | 19 Aug 2004 20:55 GMT | 9 |
I have a 93 chev K1500 throttle body that has an anoyying stumble accelerating from a stop and seems to surge at partial pedal on the highway. It seems to work fine with the pedal mashed to the floor although acceleration is lack luster. It seems to idle a little low, but with
|
| HORSEPOWER? | 19 Aug 2004 18:47 GMT | 10 |
I got a 1993 silverado stepside with a 350 in it. It came with a K&N filter, vette gears in the tranny and a Magna Performance 2 1/2 inch exhaust with no catalytic converter. Curious as to what this is putting out for horsepower. Anyone?
|
| S10 Bed Bolt Size | 19 Aug 2004 03:08 GMT | 2 |
Hello I have a new bed for my truck; Unfortunately the existing one is held on by bolts that are seized and will need to be cut off. Does anyone know what the size of the bolts are that hold the bed onto
|
| Help Question on Edelbrock Manifold 94 yukon 350 | 19 Aug 2004 00:55 GMT | 2 |
I just bought a 94 yukon and I want to go with some performance upgrades. I have installed a chip from hypertech ( Works great ) Air Raid intake Dynomax Free Flow muffler ( Ill be changing that out soon to a better exhaust headers etc )
|
| Thump in transmisin when exeleratoon 98 blasser? | 19 Aug 2004 00:25 GMT | 4 |
|
| 99 Silverado Inside Door Panel | 19 Aug 2004 00:03 GMT | 4 |
Seems I have developed a rather annoying rattle in the passenger side door of my truck. Has power windows, locks, etc. I have a Haynes manual and while there are instructions and some pictures, I
|
| 2000 S-10 dies | 18 Aug 2004 22:46 GMT | 2 |
My 2000 S-10 will just die while driving sometimes. It doesn't matter if I'm accelerating, idling, or breaking. It gives no indication that it is about to stall, no sputtering or anything. It always starts right back up. I had it at my mechanic for a week and he was unable to get it ...
|
| PING-----TransSurgeon--- | 18 Aug 2004 18:00 GMT | 2 |
. . Gary, Do you know of any top builders up in
|
| What muffler you using?? | 18 Aug 2004 17:56 GMT | 3 |
2002 5.3, ext cab, short bed. What muffler are you using and happy with as far as noise etc. Can't seem to get recomendation out of flowmaster for one without getting a whole system $500-$600 Any suggestions???? Tx
|