Can someone tell me what the operating water temperature of a
1989 350 Chevy Silverado 4 X 4 with auto trans is?
The repair shop replaced the thermostat and now my temp reads 220
degrees. This seems high to me but they say that's what it calls for.

I just came home from a 2500 mile road trip.
Now when I crank up my truck it sounds like a diesel engine for the first
2-3 seconds.
It never sounded like that before the trip.

Where is the fuel filter on a s10 V6. Or should I ask fuel filters?
Truck starts jerking after driving for about a half hour, especially
from a stop going up through the gears. When I push pedal over falf
way while driving, jerking lessens. Dirty filter?

Recently, my wifes '98 GMC Jimmy has started to make a "chattering" noise
after putting it in "D" and taking off.  It also makes this noise
periodically when backing up as well.  It almost sounds like a
metal-on-metal sound, and doesn't bog or jerk when driving.  Also, after

.

Hi to all.
I need to remove the front drivers side axle from my '89 Chevy half-ton,
4x4. Doesn't look to difficult.
My question is, do the stabilizer bar and the inner tie-rod need to be

I replaced the fuel filter last week on my Blazer, now my gas gauge is not
registering the correct amount of fuel.  I could have half a tank and it
registers almost full.  Any ideas??
RC

My brother-in-law just purchased a 2WD 5 cylinder 2004 Chevy Colorado crew
cab today.  I was wondering if anyone can direct me to a source for
aftermarket performance/cosmetic products for it.
In no particular order this is what he is looking for:

My Suburban has been dying on the road - - just plain cutting out - dead as
a door nail - no electrical power.
I can rotate the battery cables on the battery terminal and then it gets
power back to the vehicle and it'll start and run.  Sometimes it'll run for

As subject says
th gas pedal itself sticks when driving around.  pressing pedal when
truck is off it seems to be a little better.  any ideas?

Oops- I failed to follow my own rules of disassembly!
1990 K1500 350, AT, tilt wheel
Does anyone have access to a detailed schematic of the upper portion of the
steering column? I have reassembled the column up to the turn signal switch

Bought this used a few months ago - I think is sat a few years before
that.
1991 S-10 4.3L TBI
has new O2, TPI sensors.

Been really preoccupied with work lately.... finally thought to check the oil
and it wasn't even showing on the dipstick.
Added a whole quart and that got it up to two holes low.
Anybody know how much was in the system before I added that quart.

I live in Belgium Europe. Trucks that are imported often get the year they
were build replaced by the year they were imported.
Is there any way I can identify the trucks year by differences in the front
end?

I have an '97 Cheyenne 1500 of which today the turn signals stopped working.
They worked earlier this morning, but this afternoon I notice I didn't have
any. No left or right, front or rear.  I have hazard lights (same bulb and
fillament right?) but no turn signals. Anyone know what ...