Ok what is the deal with this engine?  I hate to buy the first year of any
new engine, but I am in the market for new truck.
I have an 01 2.2L Sonoma SL, and its the one I plan to replace.  Its a
really nice truck, but under powered for a work vehicle. I'ld sell it for a

My 92 Chevy Z71 Defroster is not coming on.. The floor, bi level, heat
works fine but when I press the defroster button warm/any air does not
come out of top dash.
One time after about 10 min it come on..

I'm having a lot of trouble with the passlock system in a '00 suburban that's
out of warrantee.  Does any one have advise or experience using a bypass device
such as the PL-DATA-II or PLGML that are marketed for use with remote starters?
Thanks in advance.

I am a f.cking idiot, so please no matter who you are, feel free to post
comments about me on here!! Yee haw

My 92 Chevy Z71 Defroster is not coming on.. The floor, bi level, heat
works fine but when I press the defroster button warm/any air does not
come out of top dash.
One time after about 10 min it come on..

Is this item in regard to the 2005 Silverado a mistake?:
   Front disc/rear drum anti-lock brakes are standard on all models
   except trucks with Quadrasteer.
http://trucks.about.com/od/2005chevytrucks/a/05_silverado_nf.htm

hey ya all. I'm thinking about replaceing the Universal joints on my S-10
pick up, 2 wheel drive, it has 5 of them. Two at the yoke on the axle, two
near the carrier bearing, and one near the tail shaft on the transmission.
Is there any special way that I should go about doing ...

pretty sure i am gonna have to replace my carb so i am looking for
recomendation for a new carb for my truck.  I have a 1976  350 4x4 1/2
ton pickup.  does have an eldebrock intake on it, but other than that
stock motor that was  rebuilt about 90,000 miles ago  not too concerned

Is there a bearing that can be replaced in the 1999 5.7L serpentine belt
tensioner?  Mine squeaks loudly but seems to turn freely.

Most people think the new Colorado trucks are ugly. Even the dealer
apologized when I looked at one last week and then he said but they're built
tough and that's what's important for a truck.
Older Chevy trucks are ugly too, especially back in the early 1960's. My

Has anyone tried using 10w-40 in the '02 and up 8.1L engines to see if they
still use a quart every 1K miles?
My '02 in consistently using 1 qt. every 1K miles, especially when doing
more towing of our 32' fifth-wheel. Just added another quart this weekend

I have a 97 tahoe and im having problems with the push button  4 wheel
drive. Just wanting to know if anyone has had the same problem or if anyone
knows anything about it.   Here is what it is doing.
When im in 2 wheel the light on the button is off when it is suppose to be

My '93 Burb has 200,000 miles on the origional 5.7,   The tranny was
replaced at 186,000, new fuel pump @ 190,000.  Is it still in very
good condition overall.  The 5.7 does not burn any appreciably oil,
but is getting a little sluggish.

My 2004 Tahoe came with 2 fog lights in the front valance. There are
cut-outs for 4. The open holes in the valance are butt-ugly
Does anyone know of a kit to install auxiliary driving or amber fog lights
in these cut-outs? Something plug and play preferred, since I don't want to

I have a 1972 chevy pickup
with 3 speed transmission
no-tilt wheel in the Phoenix, AZ area.
I'm looking to replace the hazard (4way) switch as it is permanently